EXTRACTOR HOOD [en] Instructions for installation and use
en Ú Table of contents [ e n ] I n s t r u c t i o n s f o r i ns t a l a t i o n a n d u s e INSTRUCTION MANUAL ..........................................................3 8 Intended use ......................................................... 3 ( Important safety information .............................. 4 7 Environmental protection.................................... 6 Ç Operating modes.................................................. 6 1 Operating the appliance ....................................
en Important safety information (Important safety information :Warning – Danger of suffocation! Packaging material is dangerous to children. Never allow children to play with packaging material. I mpor t ant saf et y i nf or mat i on : Warning – Danger of death! Risk of poisoning from flue gases that are drawn back in. Always ensure adequate fresh air in the room if the appliance is being operated in exhaust air mode at the same time as room airdependent heat-producing appliance is being operated.
Important safety information en : Warning – Risk of injury! Causes of damage ■ Caution! Risk of damage due to corrosion. Always switch on the appliance while cooking to avoid condensation. Condensate can produce corrosion damage. Components inside the appliance may have sharp edges. Wear protective gloves. Risk of injury! ■ Items placed on the appliance may fall down. Do not place any objects on the appliance.
en Environmental protection 7Environmental protection Your new appliance is particularly energy-efficient. Here you can find tips on how to save even more energy when using the appliance, and how to dispose of your appliance properly. Envi r onment al pr ot ect i on ÇOperating modes Oper at i ng modes Exhaust air mode The air which is drawn in is cleaned by the grease filters and conveyed to the exterior by a pipe system.
Operating the appliance 1Operating the appliance These instructions apply to several appliance variants. It is possible that individual features are described which do not apply to your appliance. 2Cleaning and maintenance :Warning – Risk of burns! The appliance becomes hot during operation. Allow the appliance to cool down before cleaning.
en Cleaning and maintenance Area Stainless steel Cleaning products Hot soapy water: Clean with a dish cloth and then dry with a soft cloth. Clean stainless steel surfaces in the direction of the grain only. Special stainless steel cleaning products are available from our after-sales service or from specialist retailers.Apply a very thin layer of the cleaning product with a soft cloth. Painted surfaces Hot soapy water: Clean using a damp dish cloth and then dry with a soft cloth.
Trouble shooting Installing the metal mesh grease filter : Warning – Risk of injury! Components inside the appliance may have sharp edges. Wear protective gloves. Note: Clean all accessible parts of the housing. 1. Insert the metal grease filter and lock it in place. When you do this, take hold of the metal grease filter from underneath with your other hand. Note: Make sure that the metal grease filter is positioned correctly. 2.
en Customer service 4Customer service When calling us, please give the product number (E no.) and the production number (FD no.) so that we can provide you with the correct advice. The rating plate with these numbers can be found inside the appliance (remove the metal mesh grease filter to gain access). You can make a note of the numbers of your appliance and the telephone number of the after-sales service in the space below to save time should it be required. Cust omer ser vi ce E no. FD no.
Installation instructions en INSTALLATION INSTRUCTIONS I nst al at i on i nst r uct i onsInstallation instructions HOHFWUR JD] (Important safety information [ [ [ [ [ [ [ Read these instructions carefully. Only then will you be able to operate your appliance safely and correctly. Retain the instruction manual and installation instructions for future use or for subsequent owners. Check the appliance for damage after unpacking it.
en Important safety information : Warning – Risk of death! Risk of poisoning from flue gases that are drawn back in. The exhaust air must not be conveyed into a functioning smoke or exhaust gas flue or into a shaft which is used to ventilate installation rooms that contain heating appliances. If the exhaust air is to be conveyed into a non-functioning smoke or exhaust gas flue, you must obtain the consent of the heating engineer responsible.
General information : Warning – Risk of electric shock! Components inside the appliance may have sharp edges. These may damage the connecting cable. Do not kink or pinch the connecting cable during installation. Risk of electric shock! ■ It must always be possible to disconnect the appliance from the electricity supply. The appliance must only be connected to a protective contact socket that has been correctly installed.
en Installation Electrical connection : Warning – Risk of electric shock! Components inside the appliance may have sharp edges. These may damage the connecting cable. Do not kink or pinch the connecting cable during installation. The required connection data can be found on the rating plate inside the appliance; to do this, remove the metal mesh grease filter. Length of the cable: approx. 1.30 m This appliance complies with the EC interference suppression regulations.
Installation Fitting the appliance Attaching the flue duct 1. Hook the appliance from below into the support : Warning – Risk of injury! frame. Note: Ensure that the mains cable is not trapped. 2. Fasten the appliance to the support frame using 2 securing screws. en Components inside the appliance may have sharp edges. Wear protective gloves. 1. Separate the flue ducts. To do this, remove the adhesive tape. 2. Remove the protective foil from both sides. 3.
Valid within Great Britain: Imported to Great Britain by BSH Home Appliances Ltd.
