User's Manual
Table Of Contents
- Ceiling-mounted ventilation system
- en
- Table of contents
- 1 Safety
- 2 Preventing material damage
- 3 Environmental protection and saving energy
- 4 Operating modes
- 5 Familiarising yourself with your appliance
- 6 Before using for the first time
- 7 Basic operation
- 7.1 Switching on the appliance
- 7.2 Switching off the appliance
- 7.3 Selecting a fan setting
- 7.4 Switching on intensive mode
- 7.5 Switching off intensive mode
- 7.6 Switching on the fan run-on
- 7.7 Switching off the fan run-on
- 7.8 Switch on automatic mode
- 7.9 Switch off automatic mode
- 7.10 Intermittent ventilation
- 7.11 Sensor control
- 7.12 Setting the sensor control
- 7.13 Setting the saturation indicator
- 7.14 Resetting the saturation indicator
- 7.15 Switching on the lighting
- 7.16 Setting the brightness
- 7.17 Switching on the button tone
- 7.18 Switching the button tone off
- 8 Hob-based hood control
- 9 Home Connect
- 9.1 Automatically connecting the appliance to the WLAN home network (Wi-Fi)
- 9.2 Manually connecting the appliance to the WLAN home network (Wi-Fi)
- 9.3 Connecting the appliance to the Home Connect app
- 9.4 Software update
- 9.5 Resetting the connection
- 9.6 Remote diagnostics
- 9.7 Data protection
- 9.8 Declaration of Conformity
- 10 Cleaning and servicing
- 11 Troubleshooting
- 12 Customer Service
- 13 Accessories
- 14 Disposal
- 15 Installation instructions
en Installation instructions
20
9.
Press together the cable duct at the sides and at-
tach.
Fitting the filter cover
WARNING‒Risk of injury!
Components inside the appliance may have sharp
edges.
▶
Wear protective gloves.
Risk of injury when opening and closing the hinges.
▶
Keep your hands away from the hinges.
1.
Open the hinges on the filter cover.
25
2.
Mount the filter cover on the designated screws and
push it backwards/forwards depending on the key
hole opening into the narrow section.
3.
Tighten the fastening screws on the hinges.
4.
Check whether the appliance frame is lying flush.
5
Retighten the screws if necessary.
5.
Undo the screws on the hinges up to approx.7mm.
Do not loosen them fully.
6.
Unhook and remove the filter cover.
7.
Note:Avoid scratching the side covers as they are
within view.
Insert the side covers into the corresponding open-
ings.