User's Manual
Table Of Contents
- Ceiling-mounted ventilation system
- en
- Table of contents
- 1 Safety
- 2 Preventing material damage
- 3 Environmental protection and saving energy
- 4 Operating modes
- 5 Familiarising yourself with your appliance
- 6 Before using for the first time
- 7 Basic operation
- 7.1 Switching on the appliance
- 7.2 Switching off the appliance
- 7.3 Selecting a fan setting
- 7.4 Switching on intensive mode
- 7.5 Switching off intensive mode
- 7.6 Switching on the fan run-on
- 7.7 Switching off the fan run-on
- 7.8 Switch on automatic mode
- 7.9 Switch off automatic mode
- 7.10 Intermittent ventilation
- 7.11 Sensor control
- 7.12 Setting the sensor control
- 7.13 Setting the saturation indicator
- 7.14 Resetting the saturation indicator
- 7.15 Switching on the lighting
- 7.16 Setting the brightness
- 7.17 Switching on the button tone
- 7.18 Switching the button tone off
- 8 Hob-based hood control
- 9 Home Connect
- 9.1 Automatically connecting the appliance to the WLAN home network (Wi-Fi)
- 9.2 Manually connecting the appliance to the WLAN home network (Wi-Fi)
- 9.3 Connecting the appliance to the Home Connect app
- 9.4 Software update
- 9.5 Resetting the connection
- 9.6 Remote diagnostics
- 9.7 Data protection
- 9.8 Declaration of Conformity
- 10 Cleaning and servicing
- 11 Troubleshooting
- 12 Customer Service
- 13 Accessories
- 14 Disposal
- 15 Installation instructions
Installation instructions en
19
2.
Carefully screw in diagonally opposite screws.
5
Tighten the screws one at a time so that the appli-
ance is not wedged in the cut-out.
3.
Note:To ensure that the appliance is not damaged,
do not overtighten the screws.
Carefully tighten screws in succession until the ap-
pliance is flush-mounted on the ceiling.
Connecting the appliance
1.
Press together the cable duct at the sides and re-
move it.
2.
Disconnect the cable at the appropriate point.
3.
Undo the opposite screws to loosen the fan box.
T 20
4.
Turn the fan box into the correct position according
to the installation situation.
5.
Push the fan box to the side and connect the appli-
ance to the power supply.
6.
Push the fan box to the other side and connect the
pipework.
7.
Position the fan box in the centre and screw it firmly
in place.
8.
Connect the cable.