Ceiling-mounted ventilation system [en] User manual and installation instructions I95CPS8W5, I97CQS9S5
en Safety Table of contents USER MANUAL 1 Safety .................................................................... 2 2 Preventing material damage ............................... 4 3 Environmental protection and saving energy ....................................................................... 5 4 Operating modes ................................................. 5 5 Familiarising yourself with your appliance ........ 6 6 Before using for the first time .............................
Safety rooms. Without an adequate supply of air, the air pressure falls below atmospheric pressure. Toxic gases from the flue or the extraction shaft are sucked back into the living space. ▶ Always ensure adequate fresh air in the room if the appliance is being operated in exhaust air mode at the same time as a room-air-dependent heat-producing appliance is being operated.
en Preventing material damage Risk of injury when opening and closing the hinges. ▶ Keep your hands away from the hinges. The light emitted by LED lights is very dazzling, and can damage the eyes (risk group 1). ▶ Do not look directly into the switched-on LED lights for longer than 100 seconds. Children may swallow batteries. ▶ Keep batteries out of the reach of children. ▶ Keep an eye on any children when you are replacing batteries. Batteries may explode. ▶ Do not charge the batteries.
Environmental protection and saving energy ▶ Safely dispose of empty or defective batteries in an environmentally friendly manner. There is a risk of surface damage if you do not peel off the protective film. en ▶ Remove the protective film from all parts of the ap- pliance before using for the first time. 3 Environmental protection and saving energy Help protect the environment by using your appliance in a way that conserves resources and by disposing of reusable materials properly. 3.
en Familiarising yourself with your appliance 5 Familiarising yourself with your appliance 5.1 Controls Switch the fan run-on on or off The controls are used to configure all functions of your appliance and to obtain information about the operating status. Tip: Align the remote control as precisely as possible to the infrared receiver for the LED display. Switch Home Connect on or off Reset the filter saturation indicator 1 Depending on the appliance specifications 5.
Basic operation en 7.2 Switching off the appliance 7.10 Intermittent ventilation Switch the appliance off when you are not using it. ▶ Press to switch the appliance off. a The appliance switches off. Any functions currently in progress are cancelled. With interval ventilation, the ventilation system switches on and off in the selected setting for the selected time. Note: This function is only available via a mobile device with the Home Connect app. ▶ Press or .
en Hob-based hood control 7.14 Resetting the saturation indicator 1. Press and hold After cleaning the grease filter or after changing the odour filter, the saturation indicator can be reset. Requirements ¡ After the appliance has been switched off, LED 1 flashes in the LED display for the grease filter saturation display and/or LED 2 flashes for the saturation indicator for the odour filter. ¡ A repeated signal tone sounds. ▶ Press . a The saturation indicator is reset. a 7.
Home Connect en 9 Home Connect This appliance is network-capable. Connecting your appliance to a mobile device lets you control its functions via the Home Connect app, adjust its basic settings and monitor its operating status. The Home Connect services are not available in every country. The availability of the Home Connect function depends on the availability of Home Connect services in your country. You can find information about this at: www.home-connect.com.
en Cleaning and servicing 9.4 Software update 9.7 Data protection Your appliance's software can be updated using the software update function, e.g. for the purposes of optimisation, troubleshooting or security updates. To do this, you must be a registered Home Connect user, have installed the app on your mobile device and be connected to the Home Connect server.
Cleaning and servicing ▶ Do not use hard scouring pads or cleaning sponges. ▶ Do not use any special cleaners for cleaning the appliance while it is hot. ▶ Only use glass cleaners, glass scrapers or stainless steel care products if recommended in the cleaning instructions for the relevant part. ▶ Wash sponge cloths thoroughly before use. 10.2 Cleaning the appliance Clean the appliance as specified.
en Cleaning and servicing 3. ATTENTION! Falling grease filters may damage the hob below. ▶ Grip below the grease filter with one hand. Open the locks on the grease filters. Requirement: The grease filters have been removed. → "Removing the grease filter", Page 11 1. Observe the information regarding the cleaning agents. → "Cleaning products", Page 10 2. Soak the grease filter in hot soapy water. Use special grease solvent for stubborn dirt.
Troubleshooting 2. Remove the empty batteries. en 3. Insert the new batteries (3 V CR 2032). 4. Close the cover. 5. Dispose of the empty batteries in an environmentally friendly manner. 11 Troubleshooting You can rectify minor faults on your appliance yourself. Read the troubleshooting information before contacting after-sales service. This will avoid unnecessary costs. WARNING ‒ Risk of injury! Improper repairs are dangerous.
en Customer Service 12 Customer Service If you have any queries on use, are unable to rectify faults on the appliance yourself or if your appliance needs to be repaired, contact Customer Service. Function-relevant genuine spare parts according to the corresponding Ecodesign Order can be obtained from Customer Service for a period of at least 10 years from the date on which your appliance was placed on the market within the European Economic Area.
Installation instructions en According to the European Guideline 2006/66/EC, defective or used battery packs/batteries, must be collected separately and disposed of in an environmentally correct manner. 15 Installation instructions Observe this information when installing the appliance. ≥ 305 ≥300 ≥1000 ≥ 1300 15.1 Included with the appliance ≥ 650 After unpacking all parts, check for any damage in transit and completeness of the delivery. 15.
en Installation instructions Toxic gases from the flue or the extraction shaft are sucked back into the living space. ▶ Always ensure adequate fresh air in the room if the appliance is being operated in exhaust air mode at the same time as a room-air-dependent heat-producing appliance is being operated. ▶ It is only possible to safely operate the appliance if the pressure in the room in which the heating appliance is installed does not drop more than 4 Pa (0.04 mbar) below atmospheric pressure.
Installation instructions ▶ Do not step on the hob or the work surface. The filter cover may swing out. ▶ Open the filter cover slowly. ▶ Take hold of the filter cover after opening until it no longer swings out. ▶ Close the filter cover slowly. Risk of injury when opening and closing the hinges. ▶ Keep your hands away from the hinges. WARNING ‒ Risk of electric shock! Sharp-edged components inside the appliance may damage the connecting cable. ▶ Do not kink or trap the connecting cable.
en Installation instructions ▶ The permanent electrical installation must only be wired by a professional electrician. We recommend installing a residual-current circuit breaker (RCCB) in the appliance's power supply circuit. Sharp-edged components inside the appliance may damage the connecting cable. ▶ Do not kink or trap the connecting cable. ¡ The connection data can be found on the rating plate. → Page 14 ¡ The connecting cable is approx. 1.30 m long.
Installation instructions 2. Carefully screw in diagonally opposite screws. en 4. Turn the fan box into the correct position according to the installation situation. 5 Tighten the screws one at a time so that the appliance is not wedged in the cut-out. 3. Note: To ensure that the appliance is not damaged, do not overtighten the screws. Carefully tighten screws in succession until the appliance is flush-mounted on the ceiling. 5.
en Installation instructions 9. Press together the cable duct at the sides and at- tach. 2. Mount the filter cover on the designated screws and push it backwards/forwards depending on the key hole opening into the narrow section. Fitting the filter cover WARNING ‒ Risk of injury! Components inside the appliance may have sharp edges. ▶ Wear protective gloves. Risk of injury when opening and closing the hinges. ▶ Keep your hands away from the hinges. 1. Open the hinges on the filter cover. 25 3.
Installation instructions 8. Push the side covers in the direction of the appli- ance frame and screw it firmly in place. en Removing the appliance WARNING ‒ Risk of injury! The appliance is heavy. ▶ To move the appliance, two people are required. ▶ Use only suitable tools and equipment. Components inside the appliance may have sharp edges. ▶ Wear protective gloves. Risk of injury when opening and closing the hinges. ▶ Keep your hands away from the hinges. 1.
en Installation instructions 10. Undo the opposite screws to loosen the fan box. T 20 11. Push the fan box to the side and release the pipe- work. 12. Push the fan box to the other side and pull out the mains plug. 13. Screw the fan box firmly back in place. 14. Loosen the mounting brackets. Push the removal slide inwards. 15. Slowly take the appliance out of the cutout. 16. Insert the side covers into the corresponding open- ings and screw them firmly in place.
Valid within Great Britain: Imported to Great Britain by BSH Home Appliances Ltd.
