CEILING VENTILATION [en] Instructions for installation and use
en Ú Table of contents [ e n ] I n s t r u c t i o n s f o r i ns t a l a t i o n a n d u s e INSTRUCTION MANUAL ..........................................................3 8 Intended use ......................................................... 3 ( Important safety information .............................. 4 7 Environmental protection.................................... 6 Ç Operating modes.................................................. 7 1 Operating the appliance ....................................
en Important safety information :Warning – Danger of suffocation! Packaging material is dangerous to children. Never allow children to play with packaging material. In any case, consult your responsible Master Chimney Sweep. He is able to assess the house's entire ventilation setup and will suggest the suitable ventilation measures to you. Unrestricted operation is possible if the vapour extractor hood is operated exclusively in the circulating-air mode.
Important safety information : Warning – Risk of injury! Components inside the appliance may have sharp edges. Wear protective gloves. Risk of injury! ■ The appliance may fall down if it has not been properly fastened in place. All fastening components must be fixed firmly and securely. Risk of injury! ■ The appliance is heavy. To move the appliance, 2 people are required. Use only suitable tools and equipment. Risk of injury! ■ The appliance is very heavy.
en Environmental protection Causes of damage Caution! Risk of damage due to corrosion. Always switch on the appliance while cooking to avoid condensation. Condensate can produce corrosion damage. Always replace faulty bulbs to prevent the remaining bulbs from overloading. Risk of damage due to ingress of humidity into the electronic circuitry. Never clean operator controls with a wet cloth. Surface damage due to incorrect cleaning. Clean stainless steel surfaces in the direction of the grain only.
Operating modes en ÇOperating modes 1Operating the appliance Exhaust air mode These instructions apply to several appliance variants. It is possible that individual features are described which do not apply to your appliance. If your appliance has Home Connect, more functions are only available in the Home Connect app. Oper at i ng modes The air which is drawn in is cleaned by the grease filters and conveyed to the exterior by a pipe system.
Operating the appliance en LED display Switching off Press the y button. This immediately stops the fan run-on. Intermittent ventilation LED 1 2 3 4 5 6 7 8 Explanation Fan setting 1 Fan setting 2 Fan setting 3 Intensive mode 1 Intensive mode 2 Automatic mode / fan run-on time / interval ventilation Home Connect Infrared receiver Setting the fan Switching on 1. Press the # button. The fan starts at fan setting 2. 2. Press the @ or A button to set a different fan setting.
Operating the appliance en Saturation display Lighting When the metal grease filters or the air recirculation filter are saturated after the appliance has been switched off, the corresponding symbols flash and a repeated signal tone sounds: The lighting can be switched on and off independently of the fan. Press the B button. Setting the brightness Press and hold the x or } button until the required brightness is reached.
en Connecting to a hob eConnecting to a hob You can connect this appliance to a hob (if the hob supports connection to the appliance) and then control the functions of the hood via your hob. Appliances can be connected to each other in different ways: Home Connect Two appliances can be connected using the Home Connect app provided that both of them are Home Connect compatible. Refer to the Home Connect documents supplied for more information.
Home Connect oHome Connect This appliance can be networked and also controlled using a mobile device. If the appliance is not connected to your home network, it will function as an extractor hood with no network connection and can still be operated via the display. The availability of the Home Connect function depends on the availability of Home Connect services in your country. Home Connect services are not available in every country. You can find more information on this at www.home-connect.com.
en Home Connect Connecting to the app If the Home Connect app is installed on your mobile device, you can connect it to your extractor hood. Notes ■ The appliance must be connected to the network. ■ The app must be open. 1. Press and hold the D button until LED 3 and LED 7 start flashing. 2. On your mobile device, follow the instructions in the Home Connect app. The connection process is complete when LED 7 on the appliance stops flashing and remains continuously lit.
Cleaning and maintenance 2Cleaning and maintenance Cl eani ng and mai nt enance :Warning – Risk of burns! The appliance will become hot during operation, especially near the bulbs. Allow the appliance to cool down before cleaning. : Warning Risk of electric shock! Penetrating moisture may result in an electric shock. Clean the appliance using a damp cloth only. Before cleaning, pull out the mains plug or switch off the circuit breaker in the fuse box.
en Cleaning and maintenance By hand: Note: You can use a special grease solvent for stubborn dirt. It can be ordered via the Online Shop. ■ ■ ■ 2. Open the filter cover fully and without pulling on it. Note: The filter cover may swing out. Always open and close the filter cover slowly. Ensure that the filter cover does not swing out after it is released. Soak the metal mesh grease filters in a hot soapy solution. Clean the filters with a brush and then rinse them thoroughly.
Trouble shooting Replacing the batteries in the remote control : Warning Risk of injury! Batteries can be easily swallowed by children. Keep batteries out of the reach of children. Do not allow children to change batteries without supervision. ■ Batteries may explode. Do not charge or short-circuit the batteries. Do not throw batteries into a fire. ■ The connection terminals must not be short circuited. ■ Only batteries of the specified type may be used.
Customer service en 4Customer service Accessories When calling us, please give the product number (E no.) and the production number (FD no.) so that we can provide you with the correct advice. The rating plate with these numbers can be found inside the appliance (remove the metal mesh grease filter to gain access). Note: These instructions apply to several appliance models. It may be the case that an optional accessory that is listed does not apply for your appliance.
Installation instructions en INSTALLATION INSTRUCTIONS I nst al at i on i nst r uct i onsInstallation instructions ■ ■ This appliance is fitted to the kitchen ceiling or a sturdy suspended ceiling. The surfaces of the appliance are sensitive. Avoid damaging them during installation.
en Important safety information (Important safety information Read these instructions carefully. Only then will you be able to operate your appliance safely and correctly. Retain the instruction manual and installation instructions for future use or for subsequent owners. Check the appliance for damage after unpacking it. Do not connect the appliance if it has been damaged in transport. The appliance can only be used safely if it is correctly installed according to the safety instructions.
Important safety information : Warning – Risk of fire! Fatty deposits in the grease filter may catch fire. The specified safety clearances must be complied with in order to prevent a buildup of heat. Refer to the information provided for your cooker. If gas and electric hobs are being operated together, the largest specified clearance applies. Risk of fire!deposits in the grease filter may ■ Grease catch fire. Never work with naked flames close to the appliance (e.g. flambéing).
en General information KGeneral information The surfaces of the appliance are easily damaged. Avoid damaging them during installation. Gener al i nf or mat i on Exhaust duct Note: The appliance manufacturer does not assume any warranty for complaints attributable to the pipe section. ■ ■ ■ The appliance achieves its optimum performance by means of a short, straight exhaust air pipe and as large a pipe diameter as possible.
Installation Installing the appliance 5Installation I n s t a l a t i on : Warning – Risk of injury! Components inside the appliance may have sharp edges. Wear protective gloves. Preparing for installation ■ ■ ■ en We recommend a distance of at least 700 mm and a maximum of 1500 mm. The cooking vapours are more difficult to draw in the further away they are from the hob. So that cooking vapours are optimally drawn in, install the extractor hood in the middle of the hob.
Installation en 5. Carefully screw in diagonally opposite screws. Note: Tighten the screws one at a time so that the appliance is not wedged in the cut-out. 4. Turn the fan box into the correct position according to the installation situation. 5. Push the fan box to the side and connect the power supply. 6. Carefully tighten screws in succession until the appliance is flush-mounted on the ceiling. Note: Do not overtighten the screws to ensure that the appliance is not damaged.
Installation Fitting the filter cover Removing the appliance : Warning – Risk of injury! : Warning – Risk of injury! : Warning – Risk of injury! : Warning – Risk of injury! 1. Open the hinges on the filter cover. 2. Mount the filter cover on the designated screws and 1. 2. 3. 4. Components inside the appliance may have sharp edges. Wear protective gloves. Risk of trapping body parts when opening and closing the hinges. Keep your hands away from the hinges.
*9001371508* 9001371508 991114 en
