Installation Instruction
Table Of Contents
- Ceiling-mounted ventilation system
- en
- Table of contents
- 1 Safety
- 2 Preventing material damage
- 3 Environmental protection and saving energy
- 4 Operating modes
- 5 Familiarising yourself with your appliance
- 6 Before using for the first time
- 7 Basic operation
- 7.1 Switching on the appliance
- 7.2 Switching off the appliance
- 7.3 Selecting a fan setting
- 7.4 Switching on intensive mode
- 7.5 Switching off intensive mode
- 7.6 Switching on the fan run-on
- 7.7 Switching off the fan run-on
- 7.8 Switch on automatic mode
- 7.9 Switch off automatic mode
- 7.10 Intermittent ventilation
- 7.11 Sensor control
- 7.12 Setting the sensor control
- 7.13 Setting the saturation indicator
- 7.14 Resetting the saturation indicator
- 7.15 Switching on the lighting
- 7.16 Setting the brightness
- 7.17 Switching on the button tone
- 7.18 Switching the button tone off
- 8 Home Connect
- 9 Hob-based hood control
- 10 Cleaning and servicing
- 10.1 Cleaning products
- 10.2 Cleaning the appliance
- 10.3 Cleaning the stainless steel surfaces
- 10.4 Cleaning controls
- 10.5 Removing the grease filter
- 10.6 Cleaning grease filters in the dishwasher
- 10.7 Cleaning grease filters manually
- 10.8 Fitting grease filters
- 10.9 Replacing the batteries in the remote control
- 11 Troubleshooting
- 12 Customer Service
- 13 Accessories
- 14 Disposal
- 15 Declaration of Conformity
- 16 Installation instructions
- 16.1 Included with the appliance
- 16.2 Safety clearances
- 16.3 Dimensions
- 16.4 Secure installation
- 16.5 Information on the installation situation
- 16.6 Instructions for the exhaust air pipe
- 16.7 General information
- 16.8 Instructions for the electrical connection
- 16.9 Installation
Installation instructions en
23
2.
Mount the filter cover on the designated screws and
push it backwards/forwards depending on the key
hole opening into the narrow section.
3.
Tighten the fastening screws on the hinges.
4.
Check whether the appliance frame is lying flush.
5
Retighten the screws if necessary.
5.
Insert the cable plug and close the cable duct's lid.
6.
Insert the grease filters.
To avoid causing damage, do not bend the grease
filters.
7.
Swing the filter cover up and ensure that it engages.
Removing the appliance
WARNING‒Risk of injury!
The appliance is heavy.
▶ To move the appliance, twopeople are required.
▶ Use only suitable tools and equipment.
Components inside the appliance may have sharp
edges.
▶ Wear protective gloves.
Risk of injury when opening and closing the hinges.
▶ Keep your hands away from the hinges.
1.
Disconnect the appliance from the power supply.
2.
Remove the grease filters.
To avoid causing damage, do not bend the grease
filters.
3.
Open the cable duct on the filter cover and loosen
the cable.
4.
Undo the screws on the hinges up to approx.7mm.
Do not loosen the screws fully.
5.
Unhook and remove the filter cover.
6.
Undo the screws on the top frame assembly using a
screwdriver and remove the top frame assembly.
7.
Loosen the screws on the side covers and remove
the covers.