Ceiling-mounted ventilation system [en] User manual and installation instructions I94CBS8W0
en Safety Table of contents USER MANUAL 1 Safety .................................................................... 2 2 Preventing material damage ............................... 5 3 Environmental protection and saving energy ....................................................................... 5 4 Operating modes ................................................. 6 5 Familiarising yourself with your appliance ........ 7 6 Before using for the first time .............................
Safety WARNING ‒ Risk of poisoning! Risk of poisoning from flue gases being drawn back in. Room-air-dependent heat-producing appliances (e.g. gas, oil, wood or coaloperated heaters, continuous flow heaters or water heaters) obtain combustion air from the room in which they are installed and discharge the exhaust gases into the open through an exhaust gas system (e.g. a chimney). With the extractor hood switched on, air is extracted from the kitchen and the adjacent rooms.
en Safety WARNING ‒ Risk of injury! Components inside the appliance may have sharp edges. ▶ Carefully clean the appliance interior. Items placed on the appliance may fall off. ▶ Do not place any objects on the appliance. Changes to the electrical or mechanical assembly are dangerous and may lead to malfunctions. ▶ Do not make any changes to the electrical or mechanical assembly. The filter cover may swing out. ▶ Open the filter cover slowly.
Preventing material damage en 2 Preventing material damage 2.1 Avoiding material damage ATTENTION! Condensate may cause corrosion damage. ▶ To prevent condensation from building up, switch on the appliance during cooking. If moisture gets into the controls, this may result in damage. ▶ Never clean controls with a wet cloth. Incorrect cleaning damages the surfaces. ▶ Follow the cleaning instructions. ▶ Do not use harsh or abrasive detergents.
en Operating modes 4 Operating modes 4.1 Air extraction mode The air which is drawn in is cleaned by the grease filters and conveyed to the exterior by a pipe system. The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels (not applicable to appliances that only discharge the air back into the room).
Familiarising yourself with your appliance en 5 Familiarising yourself with your appliance 5.1 Controls Switch the fan run-on on or off You can use the control panel to configure all functions of your appliance and to obtain information about the operating status. Tip: Align the remote control as precisely as possible to the infrared receiver for the LED display. Home Connect Reset the filter saturation indicator 1 Depending on the appliance specifications 5.
en Basic operation 7.2 Switching off the appliance 7.10 Intermittent ventilation Switch the appliance off when you are not using it. ▶ Press to switch the appliance off. a The appliance switches off. Any functions currently in progress are cancelled. With interval ventilation, the ventilation system switches on and off in the selected setting for the selected time. Note: This function is only available via a mobile device with the Home Connect app. ▶ Press or .
Home Connect en After cleaning the grease filter or after changing the odour filter, the saturation indicator can be reset. Requirements ¡ After the appliance has been switched off, LED 1 flashes in the LED display for the grease filter saturation display and/or LED 2 flashes for the saturation indicator for the odour filter. ¡ A repeated signal tone sounds. ▶ Press . a The saturation indicator is reset. 1. Press and hold and for approx. three seconds.
en Home Connect Requirements ¡ Wi-Fi on the router is activated. ¡ The appliance receives signals from the WLAN home network (Wi-Fi) at its installation location. ¡ The Home Connect app is installed on your mobile device. ¡ The appliance and the light are switched off. 1. Press and hold the button until LED 7 flashes in the LED display. 2. Press . a LED 1 and LED 7 flash in the LED display. 3. Press the WPS button on the router within the next 2 minutes.
Hob-based hood control en 9 Hob-based hood control You can connect your appliance to a suitable hob and, in this way, control the functions of your appliance via the hob. If both appliances are Home Connect-compatible, connect the appliances in the Home Connect app. To do this, connect the two appliances to Home Connect and follow the instructions in the app. Notes ¡ Regular security updates are provided for your appliance.
en Cleaning and servicing Clean aluminium using a soft cloth and glass cleaner. ‒ Clean plastic using a soft cloth and glass cleaner. ‒ Clean glass using a soft cloth and glass cleaner. 3. Dry with a soft cloth. 4. Apply a thin layer of the stainless steel cleaning product to stainless steel surfaces using a soft cloth. You can obtain stainless steel cleaning products from the after-sales service or the online shop. ‒ 1. Press the lock on the filter cover. 10.3 Cleaning the stainless steel surfaces 1.
Cleaning and servicing ATTENTION! The grease filters may become damaged if they are squeezed. ▶ Do not squeeze the grease filters. Note: When cleaning the grease filter in the dishwasher, light discolouration may occur. This discolouration has no effect on the performance of the metal grease filters. Requirement: The grease filters have been removed. → "Removing the grease filter", Page 12 1. Observe the information regarding the cleaning agents. → "Cleaning products", Page 11 2.
en Troubleshooting 11 Troubleshooting You can rectify minor faults on your appliance yourself. Read the troubleshooting information before contacting after-sales service. This will avoid unnecessary costs. WARNING ‒ Risk of injury! Improper repairs are dangerous. ▶ Repairs to the appliance should only be carried out by trained specialist staff. ▶ If the appliance is defective, call Customer Service. WARNING ‒ Risk of electric shock! Incorrect repairs are dangerous.
Accessories ¡ On top of the appliance. en Make a note of your appliance's details and the Customer Service telephone number to find them again quickly. 13 Accessories You can buy accessories from the after-sales service, from specialist retailers or online. Only use original accessories, as these have been specifically designed for your appliance. Accessories vary from one appliance to another. When purchasing accessories, always quote the exact product number (E no.) of your appliance.
en Installation instructions BE FR MT SE 5 GHz WLAN (Wi-Fi): BG HR NL NO For indoor CZ IT AT CH use only. DK CY PL TR AL BA MD 5 GHz WLAN (Wi-Fi): For indoor use only. ME DE LI PT IS EE LV RO UK (NI) MK RS IE LT SI EL LU SK UK ES HU FI UA 16 Installation instructions Observe this information when installing the appliance. 16.2 Safety clearances Comply with the safety clearances for the appliance. 16.
Installation instructions 16.4 Secure installation Follow these safety instructions when installing the appliance. WARNING ‒ Risk of poisoning! Risk of poisoning from flue gases being drawn back in. Room-air-dependent heat-producing appliances (e.g. gas, oil, wood or coaloperated heaters, continuous flow heaters or water heaters) obtain combustion air from the room in which they are installed and discharge the exhaust gases into the open through an exhaust gas system (e.g. a chimney).
en Installation instructions The appliance may fall down if it has not been properly fastened in place. ▶ All fastening components must be fixed firmly and securely in place. The appliance is heavy. ▶ To move the appliance, two people are required. ▶ Use only suitable tools and equipment. The appliance is heavy. ▶ The appliance must not be fitted directly onto plasterboard or similar lightweight materials.
Installation instructions 16.6 Instructions for the exhaust air pipe The appliance manufacturer does not provide any warranty for faults attributable to the pipeline. ¡ Use a short, straight exhaust air pipe with as large a pipe diameter as possible. ¡ Long, rough exhaust air pipes, many pipe bends or small pipe diameters reduce the suction power and increase the fan noise. ¡ Use an exhaust pipe that is made of non-combustible material.
en Installation instructions 3. Saw a cut-out into the ceiling. 2. Carefully screw in diagonally opposite screws. 5 4. Remove any shavings. Preparing the appliance 1. Remove the grease filters. To avoid causing damage, do not bend the grease filters. 2. Screw the flat duct connection onto the fan group. Tighten the screws one at a time so that the appliance is not wedged in the cut-out. 3. Note: To ensure that the appliance is not damaged, do not overtighten the screws.
Installation instructions 3. Disconnect the cable at the appropriate point. en 7. Push the fan box to the other side and connect the pipework. 4. Loosen the screws on the side covers and remove the covers. 8. Position the fan box in the centre and screw it firmly in place. Installation variants of the fan box The fan box can be rotated according to the installation situation. Turning the air outlet to the back 1.
en Installation instructions Turning the air outlet clockwise 1. Ausgehend vom Auslieferungszustand, den Lüfterkasten im Uhrzeigersinn drehen, sodass der Luftauslass nach rechts zeigt. 2. Undo the screw on the metal hook. 4. Press together the cable duct at the sides and at- tach. 20 5. Fit the cover frame and screw it firmly in place. 3. Das Kabel durch den Metallhaken ziehen. 4. Das Kabel in die Kabelführung 4 einhängen. 5. Tighten the screw on the metal hook so that it is firmly in place.
Installation instructions 2. Mount the filter cover on the designated screws and push it backwards/forwards depending on the key hole opening into the narrow section. en Removing the appliance WARNING ‒ Risk of injury! The appliance is heavy. ▶ To move the appliance, two people are required. ▶ Use only suitable tools and equipment. Components inside the appliance may have sharp edges. ▶ Wear protective gloves. Risk of injury when opening and closing the hinges. ▶ Keep your hands away from the hinges. 1.
en Installation instructions 8. Press together the cable duct at the sides and re- move it. 9. Disconnect the cable at the appropriate point. 12. Push the fan box to the other side and pull out the mains plug. 13. Rotate the fan box in such a way that the air outlet faces forwards. 10. Undo the opposite screws to loosen the fan box. 14. Remove the fan box. 15. Loosen the mounting brackets on the appliance us- ing a screwdriver. T 20 11. Push the fan box to the side and release the pipe- work. 16.
Valid within Great Britain: Imported to Great Britain by BSH Home Appliances Ltd.