Installation Instruction

en Installation instructions
24
17.4 Fitted units
Here, you can find notes on safe installation.
ATTENTION!
Any shavings may impair the function of electrical com-
ponents.
▶ Carry out cut-out work on the units before installing
the appliance.
▶ Remove the shavings.
¡ The minimum installation height is 850mm.
¡ The installation cabinet must not have a back panel
behind the appliance.
¡ The ventilation slots and intake openings must not
be covered.
¡ Fitted units must be heat-resistant up to 90°C, and
adjacent unit fronts up to 65°C.
17.5 Installation dimensions in the tall unit
Observe the installation dimensions and the safety
clearances in a tall unit.
17.6 Preparing the tall unit
1.
Determine the wall thickness of the unit. ⁠
An x-value is assigned to the wall thickness.
2.
Note:The x-value corresponds to the clearance
between the lower hole on the connection plate and
the bottom of the fitted unit.
Screw the connection plate tightly to the tall unit. ⁠
When doing so, observe the x-value that was de-
termined.
17.7 Installing the appliance
1.
Secure the spacers to the appliance in accordance
with the wall thickness.
2.
Note:
Do not trap or kink the power cable.
Insert the appliance into the unit and move it to the
right.
3.
Screw the appliance in until the appliance is cent-
rally aligned.
=
=