Installation Instruction
Table Of Contents
- Microwave Oven
- en
- Table of contents
- 1 Safety
- 2 Preventing material damage
- 3 Environmental protection and saving energy
- 4 Familiarising yourself with your appliance
- 5 Accessories
- 6 Before using for the first time
- 7 Basic operation
- 8 Grill
- 9 Memory
- 10 Programmes
- 11 Basic settings
- 12 Cleaning and servicing
- 13 Troubleshooting
- 14 Disposal
- 15 Customer Service
- 16 How it works
- 17 Installation instructions
- hu
- Tartalomjegyzék
- 1 Biztonság
- 2 Dologi károk elkerülése
- 3 Környezetvédelem és takarékosság
- 4 Ismerkedés
- 5 Tartozékok
- 6 Az első használat előtt
- 7 A kezelés alapjai
- 8 Grill
- 9 Memória
- 10 Programok
- 11 Alapbeállítások
- 12 Tisztítás és ápolás
- 13 Zavarok elhárítása
- 14 Ártalmatlanítás
- 15 Vevőszolgálat
- 16 Így sikerülni fog
- 17 Szerelési útmutató
- kk
- Мазмұны
- 1 Қауіпсіздік
- 2 Материалдық зияндардың алдын алу
- 3 Қоршаған ортаны қорғау және сақтау
- 4 Танысу
- 5 Керек-жарақтар
- 6 Бірінші пайдаланудан алдын
- 7 Негізгі басқару
- 8 Гриль
- 9 Жад
- 10 Бағдарламалар
- 11 Негізгі орнату жүйесі
- 12 Тазалау және күту
- 13 Ақауларды жою
- 14 Кәдеге жарату
- 15 Сервистік қызмет көрсетү
- 16 Сізде бәрі болып шығады!
- 17 Монтаждау нұсқаулығы
- ru
- Содержание
- 1 Безопасность
- 2 Во избежание материального ущерба
- 3 Защита окружающей среды и экономия
- 4 Знакомство с прибором
- 5 Аксессуары
- 6 Перед первым использованием
- 7 Стандартное управление
- 8 Приготовление на гриле
- 9 Память
- 10 Программы
- 11 Базовые установки
- 12 Очистка и уход
- 13 Устранение неисправностей
- 14 Утилизация
- 15 Сервисная служба
- 16 У Вас все получится!
- 17 Инструкция по монтажу
Installation instructions en
23
Cooking in combination with a microwave
Food Microwave
power setting
inW
Type of heating Cooking time
inmins
Note:
Potato gratin 360 35–40 Place a 22cm diameter Pyrex
dish on the turntable.
17 Installation instructions
Observe this information when installing the appliance.
17.1 Safe installation
Follow these safety instructions when in-
stalling the appliance.
¡ The appliance can only be used safely if it
is correctly installed according to the safety
instructions. The installer is responsible for
ensuring that the appliance works perfectly
at its installation location.
¡ Check the appliance for damage after un-
packing it. Do not connect the appliance if
it has been damaged in transit.
¡ Before starting up the appliance, remove
any packaging material and adhesive film
from the cooking compartment and the
door.
¡ Never remove the transparent film on the
inside of the door.
¡ Proceed in accordance with the installation
sheets for installing accessories.
¡ Fitted units must be temperature-resistant
up to 90°C, and adjacent unit fronts up to
65°C.
¡ Do not install the appliance behind a decor-
ative door or the door of a kitchen unit.
There is a risk of overheating.
¡ Cut-out work on the units should be carried
out before installing the appliance. Remove
any shavings. Otherwise, the correct opera-
tion of electrical components may be ad-
versely affected.
¡ Only a licensed professional may connect
appliances without plugs. Damage caused
by incorrect connection is not covered un-
der the warranty.
WARNING‒Risk of injury!
Parts that are accessible during installation
may have sharp edges and may lead to cut-
ting injuries.
▶ Wear protective gloves
WARNING‒Risk of fire!
It is dangerous to use an extended power
cord and non-approved adapters.
▶ Do not use extension cables or multiple
socket strips.
17.2 Electrical connection
In order to safely connect the appliance electrically, fol-
low these instructions.
WARNING‒Risk of electric shock!
Incorrect installation is dangerous.
▶ Only a qualified electrician may route the socket or
replace a power cable while taking into considera-
tion the applicable regulations.
▶ Connect the appliance only to a correctly installed,
earthed socket.
▶ If the plug is no longer accessible following installa-
tion, an all-pole isolating unit with a contact clear-
ance of at least 3mm must be available on the in-
stallation side. Contact protection must be ensured
by the installation.
17.3 Scope of delivery
After unpacking all parts, check for any damage in
transit and completeness of the delivery.