Installation Instruction
Table Of Contents
- Extractor hood
- en
- Table of contents
- 1 Safety
- 2 Avoiding material damage
- 3 Environmental protection and saving energy
- 4 Operating modes
- 5 Familiarising yourself with your appliance
- 6 Basic operation
- 6.1 Switching on the appliance
- 6.2 Switching off the appliance
- 6.3 Setting a fan setting
- 6.4 Switching on intensive mode
- 6.5 Switching off intensive mode
- 6.6 Switching on the fan run-on
- 6.7 Switching off the fan run-on
- 6.8 Switching on the AirFresh function
- 6.9 Switching on the NoiseReduction function
- 6.10 Sensor control
- 6.11 Setting the sensor control
- 6.12 Switching on the lighting
- 6.13 Setting the brightness
- 6.14 Switching on Ambient Light
- 6.15 Ambient Light - Setting the brightness
- 6.16 Ambient Light - adjusting the colour
- 6.17 Setting the intermediate position for the filter cover
- 6.18 Switching on the audible signal
- 7 Home Connect
- 8 Hob-based hood control
- 9 Cleaning and servicing
- 10 Troubleshooting
- 11 Disposal
- 12 Customer Service
- 13 Accessories
- 14 Declaration of Conformity
- 15 Installation instructions
Installation instructions en
19
4.
Note:The slots on the flue duct should point down-
wards.
Use the 2screws to screw the upper flue duct to
the sides of the retaining bracket.
5.
Note:To prevent scratches, lay soft towels over the
edges of the outer flue duct to protect the surface.
Place the lower flue duct on the appliance and pull
it slightly apart.
6.
Put the lower flue duct over the upper flue duct.
7.
Clip the lower flue duct onto the lower retaining
bracket.
Ensure that the connecting cable is not trapped.
8.
Carefully remove the towels.