Installation Instruction

en Installation instructions
18
Variant A: Flat extractor hood with flue cover
Variant A: Flat extractor hood without flue cover
Installing the appliance bracket
1.
Screw on the appliance bracket for the extractor
hood hand-tight.
2.
Use a spirit level to align the appliance bracket hori-
zontally and screw it firmly in place.
Installing the appliance
1.
Remove the protective film from the rear.
‒ Once the appliance is installed, fully remove the
protective film.
2.
Hook the appliance into the appliance bracket in
such a way that it clicks firmly into place.
3.
To align the appliance, slide the appliance to the
right or to the left as required.
4.
Tighten the safety screws.
When you install a flue cover, install the bracket and
hold it in place while screwing it in tight.
Piping
Air extraction mode
¡ If you operate the appliance in air extraction mode,
a flue cover must be installed.
Circulating-air mode
¡ If you are operating the appliance in circulating-air
mode, an optional accessory must be fitted. To do
this, refer to the installation instructions provided.
¡ For operation in circulating-air mode, the installation
of the flue cover is optional.
Note:If you are using an aluminium pipe, smooth the
connection area beforehand.
We recommend the piping with an exhaust air pipe dia-
meter of 150mm.
Installing the flue duct
WARNING‒Risk of injury!
Components inside the appliance may have sharp
edges.
▶ Wear protective gloves.
WARNING‒Risk of electric shock!
Sharp-edged components inside the appliance may
damage the connecting cable.
▶ Do not kink or trap the connecting cable.
1.
Screw the retaining bracket for the flue duct to the
wall.
2.
To separate the flue ducts, remove the adhesive
tape or the flue duct from the protective packaging.
3.
Remove any protective foil from both flue ducts.