Installation Instruction
Table Of Contents
- Extractor hood
- en
- Table of contents
- 1 Safety
- 2 Avoiding material damage
- 3 Environmental protection and saving energy
- 4 Operating modes
- 5 Familiarising yourself with your appliance
- 6 Basic operation
- 6.1 Switching on the appliance
- 6.2 Switching off the appliance
- 6.3 Setting a fan setting
- 6.4 Switching on intensive mode
- 6.5 Switching off intensive mode
- 6.6 Switching on the fan run-on
- 6.7 Switching off the fan run-on
- 6.8 Switching on the AirFresh function
- 6.9 Switching on the NoiseReduction function
- 6.10 Sensor control
- 6.11 Setting the sensor control
- 6.12 Switching on the lighting
- 6.13 Setting the brightness
- 6.14 Switching on Ambient Light
- 6.15 Ambient Light - Setting the brightness
- 6.16 Ambient Light - adjusting the colour
- 6.17 Setting the intermediate position for the filter cover
- 6.18 Switching on the audible signal
- 7 Home Connect
- 8 Hob-based hood control
- 9 Cleaning and servicing
- 10 Troubleshooting
- 11 Disposal
- 12 Customer Service
- 13 Accessories
- 14 Declaration of Conformity
- 15 Installation instructions
en Installation instructions
14
15.1 Scope of delivery
After unpacking all parts, check for any damage in
transit and completeness of the delivery.
15.2 Safety clearances
Comply with the safety clearances for the appliance.
For Australia and New Zealand the minimum safety
clearance above electrical cooktops must be 600 mm.
15.3 Appliance dimensions
You will find the dimensions of the appliance here
15.4 Installation recommendation
We recommend fitting the appliance such that the
lower edge of the glass screen is in line with the lower
edges of the adjacent wall-hung cabinets.
B
B
Maintain the safety clearances to the hob. →Page14