Installation Instruction
Table Of Contents
- Extractor hood
- en
- Table of contents
- 1 Safety
- 2 Avoiding material damage
- 3 Environmental protection and saving energy
- 4 Operating modes
- 5 Familiarising yourself with your appliance
- 6 Basic operation
- 7 Cleaning and servicing
- 8 Troubleshooting
- 9 Disposal
- 10 Customer Service
- 11 Accessories
- 12 Installation instructions
- 12.1 Scope of delivery
- 12.2 Safety clearances
- 12.3 Appliance dimensions
- 12.4 Secure installation
- 12.5 General information
- 12.6 Instructions for the electrical connection
- 12.7 Information on the installation situation
- 12.8 Instructions for the exhaust air pipe
- 12.9 Instructions for the air extraction mode
- 12.10 Installation
en Installation instructions
16
3.
Remove any protective foil from both flue ducts.
4.
Note:The slots on the flue duct should point down-
wards.
Push one flue duct section into the other.
5.
Note:To prevent scratches, lay soft towels over the
edges of the outer flue duct to protect the surface.
Place the flue duct sections on the appliance.
6.
Slide the inner flue duct section upwards, and at-
tach it to the left- and right-hand sides of the retain-
ing bracket.
7.
Engage the flue duct section downwards.
8.
Screw the flue duct section to the sides of the re-
taining bracket using two screws.
9.
Use two screws to secure the outer flue duct sec-
tion to the appliance from below.
10.
Carefully remove the towels.