Operating/installations instructions
Table Of Contents
- en Instructions for installation and use
- Table of contents
- Instruction manual
- 8 Intended use
- ( Important safety information
- 7 Environmental protection
- Ç Operating modes
- 1 Operating the appliance
- 2 Cleaning and maintenance
- 3 Trouble shooting
- 4 Customer service
- Installation instructions
- ( Important safety information
- K General information
- 5 Installation
- Installation
- Preparing the installation
- Installation
- Attaching and aligning the appliance
- 1. First, remove the protective foil from the back of the appliance and, following installation, remove the foil completely.
- 2. When attaching the appliance, ensure that it engages firmly with the brackets. «
- 3. Align the appliance horizontally by turning the brackets. If required, the appliance can be moved to the right or left. ¬
- 4. Firmly tighten the screws for the brackets. When doing so, hold the brackets securely in place. ®
- 5. Firmly tighten the knurled nuts. ¯
- Connecting the pipes
- Attaching the flue duct
Installation en
13
5Installation
Installation
Preparing the installation
Caution!
Ensure that there are no electric wires, gas or water
pipes in the area where holes are to be made.
1. Mark a vertical centre line on the wall from the
ceiling to the lower edge of the extractor hood.
2. Mark positions for the screws and the contour of the
attachment area.
3. Drill five 8 mm diameter holes to a depth of 80 mm
for the attachments and press in the wall plugs flush
with the wall.
Installation
1. Screw on the fixing bracket for the flue duct. ¨
2. Screw on brackets for the extractor hood hand-tight.
Do not firmly tighten the screws. ©
3. Screw in the threaded bolt, leaving it protruding out
of the wall by 5–9 mm. ª
[
PP
PP
PP
PP
PP
[
$
[
%
NJONN
NBYNN
&