User's Manual
Table Of Contents
- Extractor hood
- en
- Table of contents
- 1 Safety
- 2 Avoiding material damage
- 3 Environmental protection and saving energy
- 4 Operating modes
- 5 Familiarising yourself with your appliance
- 6 Accessories
- 7 Basic operation
- 8 Cleaning and servicing
- 9 Troubleshooting
- 10 Disposal
- 11 Customer Service
- 12 Installation instructions
- 12.1 Scope of delivery
- 12.2 Appliance dimensions
- 12.3 Safety clearances
- 12.4 Secure installation
- 12.5 General information
- 12.6 Instructions for the electrical connection
- 12.7 Information on the installation situation
- 12.8 Instructions for the exhaust air pipe
- 12.9 Instructions for the air extraction mode
- 12.10 Information about circulating-air mode
- 12.11 Installation
- 12.11.1 Checking the unit
- 12.11.2 Preparing the units
- 12.11.3 Preparing the appliance
- 12.11.4 Preparing circulating-air mode
- 12.11.5 Installing the appliance
- 12.11.6 Establishing the exhaust air connection
- 12.11.7 Establishing the connection for the circulated air
- 12.11.8 Connecting to the power supply
- 12.11.9 Removing the appliance
Installation instructions en
15
Removing the appliance
WARNING‒Risk of injury!
Components inside the appliance may have sharp
edges.
▶ Wear protective gloves.
1.
Disconnect the appliance from the power supply.
2.
Loosen the exhaust pipe.
3.
Open the filter cover if required.
4.
Remove the grease filters.
To avoid causing damage, do not bend the grease
filters.
5.
Remove the frame.
6.
Undo the control panel cabling and cabling for the
lighting.
7.
Loosen the screw connection with the fitted unit.
8.
Slowly take the appliance down.