Assembly Instructions

Installation instructions en
27
3.
Fit the one-way flaps on the air outlet and click them
into place.
Note:If the fitted unit is no longer accessible after the
appliance is installed, remove the side locking mechan-
ism. To do this, undo the fastening screws and secure
these to the appliance's housing.
Installing the appliance
1.
ATTENTION!
If you already have a cut-out for a previous model of
the same brand, the latching mechanism does not
engage.
▶ Secure the appliance so that it does not fall
down and become damaged.
Place the appliance in the cut-out ⁠.
New cut-out
Cut-out for a previous model
2.
Tighten the fastening screws ⁠.
If you are using a cut-out for a previous model, you
may not be able to use the side screws ⁠.
3.
Secure the panel.
‒ Push the panel upwards until the latching mech-
anism engages.
4.
Fit the grease filters.
To avoid causing damage, do not bend the grease
filters.
5.
Insert the mains plug into the protective contact
socket.
Removing the appliance
WARNING‒Risk of injury!
Components inside the appliance may have sharp
edges.
▶ Wear protective gloves.
1.
Disconnect the appliance from the power supply.
2.
Loosen the exhaust pipe.
3.
Remove the grease filters.
To avoid causing damage, do not bend the grease
filters.
4.
Remove the panel.
5.
Loosen the screw connection with the fitted unit.
6.
In order to loosen the fixing, use a screwdriver as a
lever. To do this, guide the screwdriver through the
lateral slot.
7.
Slowly take the appliance down.