Assembly & Installation Instructions

Installation en

4. Screw in the filler strip fully.

5. Push in the fastening bolt and turn it 90°.

Note: The fastening pieces on the left and right of

the appliance must be able to move.

Final fitting stage

1. Slide the appliance up into place. ¨

2. Lock the fastening bolts on the left and right. ©

3. Fit the protective caps on the left and right. ª

4. Establish the electrical connection.

Note: The extractor hood's housing can be concealed

within the upper cabinet. In doing so, you must observe

the following:

■ The intermediate floor must not be placed on the

extractor hood's housing.

■ The front panel must not be secured to the housing.

■ Access must be available in order to change the

filter and for the after-sales service.

Appliance width 90 cm:

You must also screw the appliance to the wall-hanging

cupboards either side of it.

Changing the filter pull-out's limit stop

On some versions of the appliance, the limit stop for the

filter pull-out can be changed. Spacers are included

with these appliances in order to position the

appliance's handle strip flush with the fitted unit.

1. Pull the filter pull-out towards you.

2. Shorten the spacer to the required dimension and

insert it into the slot specified.

PP

[

[

PP