[en] Instructions for installation and use Extractor hood
Ú Table of contents e[nuoIrs]acitlfde INSTRUCTION MANUAL............................................................ 2 Important safety information................................................ 2 Environmental protection ..................................................... 5 Environmental protection..............................................................5 Operating modes................................................................... 5 Exhaust air mode .........................................
Danger of suffocation! Packaging material is dangerous to children. Never allow children to play with packaging material. Danger of death! Risk of poisoning from flue gases that are drawn back in. Always ensure adequate fresh air in the room if the appliance is being operated in exhaust air mode at the same time as room air-dependent heat-producing appliance is being operated. In any case, consult your responsible Master Chimney Sweep.
Risk of burns! The accessible parts become very hot when in operation. Never touch hot parts. Keep children at a safe distance. Risk of injury! ■ Components inside the appliance may have sharp edges. Wear protective gloves. ■ Items placed on the appliance may fall down. Do not place any objects on the appliance. ■ The light emitted by LED lights is very dazzling, and can damage the eyes (risk group 1). Do not look directly into the switched on LED lights for longer than 100 seconds.
Environmental protection Unpack the appliance and dispose of the packaging in an environmentally-responsible manner. Environmental protection This appliance is labelled in accordance with the European Directive 2012/19/EU concerning used electrical and electronic appliances (WEEE – waste electrical and electronic equipment). The guideline determines the framework for the return and recycling of used appliances as applicable.
Operation These instructions apply to several appliance variants. It is possible that individual features are described which do not apply to your appliance. Note: Switch on the extractor hood when you start cooking and switch it off again several minutes after you have finished cooking. This is the most effective way of removing the kitchen fumes. Control panel model 1 Control panel Fan run-on time Press the - button until – appears. After approx. ten minutes, the fan switches off automatically.
Control panel model 2 Fan run-on time Control panel Press the - button until – appears. After approx. ten minutes, the fan switches off automatically. YRO IUHVK YRO AirFresh function Press the - button until 3‚ appears. The fan runs for approx. five minutes per hour.
Cleaning and maintenance : Risk of burns! Cleaning the metal mesh grease filters The appliance will become hot during operation, especially near the bulbs. Allow the appliance to cool down before cleaning. : Risk of fire! : Risk of electric shock! Penetrating moisture may result in an electric shock. Clean the appliance using a damp cloth only. Before cleaning, pull out the mains plug or switch off the circuit breaker in the fuse box.
Removing metal mesh grease filter 1. Open the lock and fold down the metal grease filter. While doing this, place the other hand under the metal grease filter. For additional filters, open the lock and fold down the metal grease filter. While doing this, place the other hand under the metal grease filter. 2. Take the metal grease filter out of the holder. Notes For edge extraction filters, pull the metal grease filter downwards. While doing this, place the other hand under the metal grease filter.
After-sales service Our after-sales service is there for you if your appliance needs to be repaired. We will always find the right solution in order to avoid unnecessary visits from a service technician. Basic equipment: Starter set for circulating-air mode - wide 3 When calling us, please give the product number (E no.) and the production number (FD no.) so that we can provide you with the correct advice.
INSTALLATION INSTRUCTIONS Installation instructions [ PLQ PP PLQ PP PD[ PP [ PP PLQ PP [ [ [ [ [ [ [ ■ ■ ! PP ■ This appliance is installed on the wall. Follow the enclosed installation instructions for additional special accessories (e.g. for circulating-air mode). The surfaces of the appliance are sensitive. Avoid damaging them during installation. ! PP : Important safety information Read these instructions carefully.
Room air-dependent heat-producing appliances (e.g. gas, oil, wood or coaloperated heaters, continuous flow heaters or water heaters) obtain combustion air from the room in which they are installed and discharge the exhaust gases into the open air through an exhaust gas system (e.g. a chimney). In combination with an activated vapour extractor hood, room air is extracted from the kitchen and neighbouring rooms - a partial vacuum is produced if not enough fresh air is supplied.
General information Exhaust air mode Checking the wall : Risk of death! ■ Risk of poisoning from flue gases that are drawn back in. The exhaust air must not be conveyed into a functioning smoke or exhaust gas flue or into a shaft which is used to ventilate installation rooms that contain heating appliances. If the exhaust air is to be conveyed into a non-functioning smoke or exhaust gas flue, you must obtain the consent of the heating engineer responsible.
Installation Attaching and aligning the appliance 1. Screw on the fixing bracket for the flue duct. ¨ 1. Initially remove the protective foil from the back of the $ appliance and, following installation, remove the foil completely. 2. When attaching the appliance, ensure that it engages firmly with the brackets. « 3. Align the appliance horizontally by turning the brackets. If required, the appliance can be moved to the right or left. ¬ [ ' ( 2.
Removing the safety caps If the safety caps must be removed, use a flat screwdriver. Attaching the flue duct : Risk of injury! From sharp edges during installation. Always wear protective gloves while installing the appliance. 1. Separate the flue ducts. To do this, remove the adhesive tape. 2. Remove the protective foil from both flue ducts. 3. Push one flue duct into the other.
Constructa Neff Vertriebs-GmbH Carl-Wery-Straße 34 D-81739 München *9000852731* 9000852731 931007
