Assembly & Installation Instructions
Table Of Contents
- DHU642PGB, DHU645PGB, DHU646PGB, D16BS01N0B, D16BS01S0B, D16BS01W0B
- : Important safety information
- General information
- Installation preparation
- Installing the appliance on a wall unit
- 1. Use the drill jig or the hole pattern to mark out where the holes are to be drilled. (Fig. 1)
- 2. If necessary, cut out the opening for the exhaust air pipe in the correct position in the upper cabinet for air extraction mode.
- 3. For circulating-air mode, fit the two blind plugs to the rear and upper exhaust air openings. (Fig. 2)
- 4. Position the extractor hood below the base plate of the upper cabinet.
- 5. Use four screws to secure the appliance to the base plate of the upper cabinet from above.
- Installing the appliance on a wall
- Caution!
- 1. Use the drill jig or the hole pattern to drill the holes. (Fig. 1)
- 2. Press in the wall plugs flush with the wall.
- 3. Screw on the angle bracket.
- 4. If necessary, cut out the opening for the exhaust air pipe in the correct position in the wall-hanging cupboard for air extraction mode.
- 5. For circulating-air mode, fit the two blind plugs to the rear and upper exhaust air openings. (Fig. 2)
- 6. Fit the appliance.
- 7. Remove the filter grid; see the instruction manual.
- 8. Align the appliance horizontally using the two screws. (Fig. 3)
- 9. Screw the safety bracket securely to the wall over the appliance. This will ensure that the appliance cannot slip out of the bracket and fall if it is unintentionally hit from below. (Fig. 4)
- Caution!
- Connecting the appliance to the power supply
- Removing the appliance