Instruction manual

ManualsBrandsNEFF ManualsAll Ovens45cm Compact Pyrolytic Built-In Combi-Microwave Oven

en Steam

Do not use distilled water, highly chlorinated tap water

(> 40 mg/l) or other liquids.

Only use cold, fresh tap water, softened water or

uncarbonated mineral water.

Caution!

Malfunctions may occur when using filtered or

demineralised water.

The appliance may request that you top up the water

tank even though it may be full, or operation with steam

is cancelled after approx. two minutes.

If required, mix filtered or demineralised water with the

bottled non-carbonated mineral water with a ratio of

one to one.

Notes

■ If your water is very hard, we recommend that you

use softened water.

■ If you use only softened water, you can set your

appliance to the "softened" water hardness range.

■ If you use mineral water, set the water hardness

range to "4 very hard".

■ If you use mineral water, you must only use non-

carbonated mineral water.

1. Touch the ” touch button.

The control panel is automatically pushed forwards.

2. Pull the control panel forwards with both hands and

then push it upwards until it locks into place (fig.

!).

3. Lift the water tank and remove it from the water tank

recess (fig. ").

4. Press down on the lid along the seal to prevent

water from leaking out of the water tank.

5. Remove the cover ‚ (fig. #).

6. Fill the water tank with cold water up to the “max.”

mark (fig.

$).

7. Reinsert the cover ‚ into the opening in the water

tank.

8. Insert the filled water tank (fig. %). Ensure that the

water tank locks into place behind both holders ƒ

(fig.

&).

9. Slowly push the control panel downwards and then

towards the rear until it is closed completely.

The water tank has been filled. You can start

operations with steam.

Refilling the water tank

Notes

■ Steam-assisted operations continue without adding

steam.

■ If the water tank runs dry during operation with the

Dough proving or Reheat settings, operation is

interrupted. Fill the water tank.

1. Open the control panel.

2. Remove and refill the water tank.

3. Insert the filled water tank and close the control

panel.







I