Assembly & Installation Instructions

Rails en
29
3.
Remove limescale with a cloth soaked in vinegar.
Then wipe with clean water and rub dry with a soft
cloth (including under the door seal).
4.
If there is any stubborn dirt that you are unable to
remove, run the cleaning aid again once the cook-
ing compartment has cooled down.
5.
In order to dry the cooking compartment, leave the
appliance door open in the detent position (approx.
30°) for approx.one hour.
20 Rails
To thoroughly clean the rails and the cooking compart-
ment, or to replace the rails, you can remove the rails.
20.1 Detaching the rails
WARNING‒Risk of burns!
The shelf supports get very hot
▶ Never touch the shelf supports when hot.
▶ Always allow the appliance to cool down.
▶ Keep children at a safe distance.
1.
Pull out the pull-out forwards.
2.
Lift the rail forwards slightly ⁠ and detach it ⁠.
3.
Swivel the entire rail outwards ⁠ and unhook it at
the rear ⁠.
20.2 Fitting the retainers
The retainers may fall out when you detach the rails.
Note:
The retainers at the front differ from those at the rear.
1.
Hook the front retainers with the hook into the round
hole at the top and set them at a slight angle ⁠.
2.
Hook the front retainers in at the bottom and
straighten them ⁠.
3.
Hook the rear retainers with the hook into the top
hole ⁠ and push them into the bottom hole ⁠.
20.3 Attaching the rails
Notes
¡ When hanging the rails, ensure that the pull-out is at
the bottom.
¡ The rails only fit on the right or left.
¡ For both pull-out rails, ensure that you can pull them
forwards and out.
1.
Set the rear rail at an angle, hooking it into the re-
tainers at the top and bottom ⁠.
2.
Pull the rail forwards ⁠.