Assembly & Installation Instructions

Table Of Contents
en Installation instructions
34
Recommended settings for baking
Food Accessory/cookware Shelf pos-
ition
Heating
function
→Page8
Temperature in
°C
Cooking time in
mins
Viennese whirls Baking tray 1 ⁠ 150 - 160
1
25 - 40
Viennese whirls Baking tray 1 ⁠ 140 - 150
1
25 - 40
Viennese whirls, on 2levels Universal pan
+
Baking tray
3+1 ⁠ 140 - 150
1
30 - 40
Small cakes Baking tray 1 ⁠ 160
1
25 - 35
Small cakes Baking tray 1 ⁠ 150
1
25 - 35
Small cakes, on 2levels Universal pan
+
Baking tray
3+1 ⁠ 150
1
25 - 35
Hot water sponge cake Springform cake tin,
diameter 26 cm
1 ⁠ 160 - 170
2
25 - 35
Hot water sponge cake Springform cake tin,
diameter 26 cm
1 ⁠ 160 - 170
2
25 - 35
1
Preheat the appliance for five minutes. Do not use the rapid heating function.
2
Preheat the appliance. Do not use the rapid heating function.
Recommended settings for grilling
Food Accessory/cookware Shelf pos-
ition
Heating
function
→Page8
Temperature in
°C
Cooking time in
mins
Toasting bread Wire rack 3 ⁠ 290 2 - 6
24  Installation instructions
Observe this information when installing the appliance.
 24.1 General installation instructions
Follow these instructions before you start with
the installation of the appliance.
¡ The safe operation of this appliance can
only be guaranteed if it has been installed
to a professional standard in accordance
with these installation instructions. The in-
staller shall be liable for damages incurred
as a result of incorrect installation.
¡ Check the appliance for damage after un-
packing it. Do not connect the appliance if
it has been damaged in transit.
¡ Before starting up the appliance, remove
any packaging material and adhesive film
from the cooking compartment and the
door.
¡ Proceed in accordance with the installation
sheets for installing accessories.
¡ Fitted units must be heat-resistant up to
95°C, and adjacent unit fronts up to
70°C.
¡ Do not install the appliance behind a decor-
ative door or the door of a kitchen unit.
There is a risk of overheating.
¡ Cut-out work on the units should be carried
out before installing the appliance. Remove
any shavings. Otherwise, the correct opera-
tion of electrical components may be ad-
versely affected.
¡ The mains socket for the appliance must
either be located in the hatched area ⁠ or
outside of the area where the appliance is
installed.
Any unsecured units must be secured to
the wall using a standard bracket ⁠.