Assembly & Installation Instructions

Appliance door en
21
3.
Hook the rear retainers with the hook into the top
hole and push them into the bottom hole ⁠.
15.3 Attaching the rails
Notes
¡ When hanging the rails, ensure that the sloping
edge is at the top of the rail.
¡ The rails fit both the left- and right-hand sides.
1.
Set the rear rail at an angle, hooking it into the re-
tainers at the top and bottom ⁠.
2.
Pull the rail forwards ⁠.
3.
Hook in the rail at the front and press it down .
16 Appliance door
To clean the appliance door thoroughly, you can disas-
semble the appliance door.
16.1 Removing the door cover
The stainless steel inlay in the door cover may discol-
our. Remove the door cover in order to clean it and the
stainless steel inlay, or to remove the door panes.
1.
Open the appliance door slightly.
2.
Press down on the left- and right-hand sides of the
door cover.
3.
Remove the door cover and carefully close the ap-
pliance door.
16.2 Removing the door panes
WARNING‒Risk of injury!
Scratched glass in the appliance door may develop
into a crack.
▶
Do not use any harsh or abrasive cleaners or sharp
metal scrapers to clean the glass on the oven door,
as they may scratch the surface.
The hinges on the appliance door move when the door
is opened and closed, which could trap your fingers.
▶
Keep your hands away from the hinges.
Components inside the appliance door may have sharp
edges.
▶
Wear protective gloves.
Requirement:The door cover has been removed.
1.
Undo and remove the screws on the left and right of
the appliance door.
2.
Place a folded-up tea towel in the appliance door.
3.
Close the appliance door.
4.
Pull the front pane up and out.
5.
Place the front pane down on a flat surface with the
door handle facing down.