Operation Manual

en Operating the appliance
12
Default values
The appliance suggests a temperature or setting for
each type of heating. You can accept this value or
change it in the appropriate area.
Heating bar
As soon as a type of heating has started, the heating
bar appears on the display.The heating bar shows the
temperature increase in the cooking compartment.
Note: The temperature indicator is not displayed for the
steaming ‹ type of heating.
Displaying the current temperature
To show the current temperature on the display, press
the ! touch button.
The current temperature is shown briefly only when
heating up.
Further information
If the ! touch button lights up, information can be
displayed. Touch the ! touch button to do this. The
information is displayed for a few seconds.
Changing or cancelling the appliance
operation
Changing the appliance operation
1. Use the # button to stop the operation.
2. Use the & or % button to navigate to the line for the
setting that should be changed.
3. Use the ( or ) button to change the setting.
4. Use the # touch button to start the changed
operation.
Note: The cooling fan may continue to run while an
operation is interrupted.
Cancelling the appliance operation
Press and hold the # touch button until the appliance
operation is cancelled.
Note: The Descale function cannot be cancelled.
After each use
:Warning – Risk of scalding!
When you open the appliance door, hot steam can
escape. Steam may not be visible, depending on its
temperature. When opening, do not stand too close to
the appliance. Open the appliance door carefully. Keep
children away.
Moisture and dirt remain in the cooking compartment
after each operation. Therefore dry and clean the
appliance after each use. Also empty the water tank
after each use.
Drying the cooking compartment
:Warning – Risk of scalding!
The water in the evaporator dish may still be hot. Allow
it to cool before wiping.
1. Leave the appliance door ajar until the appliance has
cooled down.
2. Remove any dirt from the cooking compartment
immediately.
3. Wipe out the cooled cooking compartment and
evaporator dish with the cleaning sponge and dry
with a soft cloth.
4. Wipe the front of the units dry if condensation has
formed.
Emptying the water tank
The water tank must be emptied and dried after each
steam operation.
Caution!
■ Do not dry the water tank in the hot cooking
compartment. This will damage the water tank.
■ Do not clean the water tank in the dishwasher.This
will damage the water tank.
1. Open the appliance door.
2. Remove the water tank and empty the residual
water.
3. Thoroughly dry the seal in the tank cover and the
water tank recess in the appliance.
4. Insert the water tank into the water tank recess.
5. Close the appliance door.