User Manual

Operating the appliance en
11
3. Set the heating type, temperature and cooking time,
then start the appliance operation. ~ "Setting and
starting the appliance operation" on page 12
4. Use the # touch button to switch off the appliance.
5. Wait until the cooking compartment has cooled
down.
6. Clean the smooth surfaces with soapy water and a
dish cloth.
7. Empty the water tank and dry the cooking
compartment. ~ "After each use" on page 13
Notes
■ So that the appliance adapts to a new installation
location after moving house, reset the appliance to
the factory settings. Repeat the initial use settings
and the calibration.
■ The appliance saves the calibration settings, even in
the event of a power cut or disconnection from the
mains.It must not be calibrated again.
Cleaning the accessories
Clean the accessories thoroughly using soapy water
and a dish cloth or soft brush.
1Operating the appliance
Operating the appliance You have already learnt about the controls and how
they work. Now we will explain how to set your
appliance. You will learn about what happens when you
switch the appliance on and off, and how to select the
operating mode.
:Warning – Risk of scalding!
When you open the appliance door, hot steam can
escape. Steam may not be visible, depending on its
temperature. When opening, do not stand too close to
the appliance. Open the appliance door carefully. Keep
children away.
:Warning – Risk of scalding!
The water in the evaporator dish is still hot even after
the appliance has been switched off. Do not empty the
evaporator dish immediately after switching off the
appliance. Allow the appliance to cool down before
cleaning it.
Switching the appliance on and off
Touch the # touch button to switch the appliance on or
off.
After switching off the appliance, on the display you can
see how high the residual heat in the cooking
compartment is.
Notes
■ Certain displays and notes, such as the residual heat
in the cooking compartment, remain visible on the
display even when the appliance is switched off.
■ After an appliance operation, the cooling fan runs on
audibly until the cooking compartment has been
cooled as far as possible.
■ Switch off your device when you do not need to use
it. If no settings are applied for a long time, the
appliance switches itself off automatically.
Filling the water tank
When you open the appliance door, you will see the
water tank on the right-hand side. Before starting the
operation, fill the water tank with water.
Ensure that you have correctly set the water hardness
range. ~ "Basic settings" on page 18
Caution!
The appliance may become damaged due to the use of
unsuitable liquids.
Do not use distilled water, highly chlorinated tap water
(> 40 mg/l) or other liquids.
Only use cold, fresh tap water, softened water or
uncarbonated mineral water.
Settings
Heating type Steam ‹
Temperature 100 °C
Cooking time 20 minutes
Display Meaning
-h- Residual heat (between 60 °C and 100 °C)