Instructions for Use

en Trouble shooting
24
8. Clean the door panels on both sides with glass
cleaner and a soft cloth.
:Warning
Risk of injury!
Scratched glass in the appliance door may develop
into a crack. Do not use glass scrapers, or sharp or
abrasive cleaning aids or detergents.
9. Dry the door panels and refit them.
Fitting
Note: When fitting the door panels, make sure that they
are in the original order.
1. Insert the intermediate panel so that the ‚ arrow on
the right-hand side is pointing upwards (Fig. !).
2. Check the fit of the four spacers and two seals on
the intermediate panel:
– Position the spacers so that each of the lines
runs through the centre (Fig. ").
– Attach the seals at the corners (Fig. #).
3. Insert the intermediate panel with the seals and
spacers. The arrow on the intermediate panel must
line up with the arrow on the frame (Fig. $).
4. Insert the second intermediate panel without the
seals and spacers and push it in the direction of the
arrow until it is fitted in the frame. The arrow on the
intermediate panel must line up with the arrow on the
frame (Fig. %).
5. Push down on the intermediate panel around ƒ, slide
the holder „ in at an angle and push down until it
clicks into place (Fig. &).
The holder has been inserted (Fig. ').
6. Insert the inner glass into the mounting rail … at an
angle towards the back (Fig. ().
7. Push the inner glass downwards until it clicks into
place (Fig. )).
3Trouble shooting
Tr o ubl e s hoot i ng If a fault occurs, there is often a simple explanation.
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Rectifying faults yourself
You can often easily rectify technical faults with the
appliance yourself.
If a dish does not turn out exactly as you wanted, you
can find useful cooking tips and instructions at the end
of this instruction manual. ~ "Tested for you in our
cooking studio" on page 26
1
D

2


Fault Possible
cause
Notes/remedy
The appliance is
not working.
Defective cir-
cuit breaker.
Check the circuit breaker in the
fuse box.
Power failure Check whether the kitchen light
or other kitchen appliances are
working.
The time is flash-
ing on the display.
Power failure. Reset the time.
After switching on
an operating
mode, œ flashes
in the display.
The appliance
has not
cooled down
sufficiently.
Switch off the appliance, allow it
to cool down and switch the oper-
ating mode on again.


F
E

G
G
