Installation instructions

en Cleaning functions
28
Configuring the Pyrolytic self-cleaning function
WARNING‒Risk of harm to health!
The cleaning function heats up the cooking compart-
ment to a very high temperature so that food left over
from roasting, grilling and baking will burn off. This pro-
cess releases vapours, which can irritate mucous mem-
branes.
▶ Keep the kitchen well ventilated while the cleaning
function is running.
▶ Do not remain in the room for long periods.
▶ Keep children and pets away.
WARNING‒Risk of burns!
The cooking compartment gets very hot when the
cleaning function is in progress.
▶ Never open the appliance door.
▶ Allow the appliance to cool down.
▶ Keep children at a safe distance.
The outside of the appliance gets very hot when the
cleaning function is in progress.
▶ Never touch the appliance door.
▶ Allow the appliance to cool down.
▶ Keep children at a safe distance.
Note:The oven light will not be lit while the cleaning
function is running.
Requirement:.
1.
Press ⁠ to switch the appliance on.
2.
Press ⁠.
3.
Swipe left or right to set "Pyrolytic self-cleaning" ⁠.
4.
Press the bottom row.
5.
Swipe left or right to select the required cleaning
setting.
Cleaning set-
ting
Cleaning
level
Duration in hours
1 Low Approx. 1:15
2 Medium Approx. 1:30
3 High Approx. 2:00
Select a higher cleaning setting if the cooking com-
partment is particularly dirty or has not been
cleaned for a while.
You cannot change the duration of the cleaning
function.
Once the cleaning function is in progress, you can-
not change the cleaning setting.
a The duration of the cleaning setting will appear on
the display.
6.
Press the bottom row.
7.
Note:Keep the kitchen ventilated while the cleaning
function is running.
Press ⁠ to start the cleaning function.
a The cleaning function will start. The duration will
count down on the display.
a For your safety, the appliance door locks the cook-
ing compartment. ⁠ will appear on the display.
a Once the cleaning function has run through to the
end, an audible signal will sound.
8.
Press ⁠ to switch the appliance off.
The appliance door will remain locked until the ap-
pliance has cooled down sufficiently and ⁠ has
gone out.
9.
After using the cleaning function, prepare the appli-
ance so that it is ready to use again.
Preparing the appliance for use following the
cleaning function
1.
Allow the appliance to cool down.
2.
Wipe off any ash that has been left behind in the
cooking compartment and around the appliance
door with a damp cloth.
3.
Remove white residues with lemon juice.
Note:White residues on the enamel surfaces may
be caused by heavy soiling. These food residues
are harmless. The deposits do not compromise the
functionality of the appliance.
4.
Attach the shelf supports.
→"Rails", Page30
19.2 EasyClean cleaning aid
You can use the "EasyClean" cleaning aid to clean light
soiling from the cooking compartment between full
cleans. The "EasyClean" cleaning aid soaks dirt by
evaporating soapy water. It is then easier to remove the
dirt.
Setting the EasyClean cleaning aid
WARNING‒Risk of scalding!
If there is water in the cooking compartment when it is
hot, this may create hot steam.
▶ Never pour water into the cooking compartment
when the cooking compartment is hot.
Requirements
¡ You can only start the cleaning aid once the cooking
compartment is cold (room temperature) and the ap-
pliance door is closed.
¡ Do not open the appliance door while the appliance
is in operation, as this will abort the cleaning aid.
¡ To remove particularly stubborn dirt, leave the soapy
water to work for a while before starting the cleaning
aid.
¡ To remove particularly stubborn dirt, rub washing-up
liquid onto dirty areas on the smooth surfaces before
starting the cleaning aid.
1.
Remove any accessories from the cooking compart-
ment.
2.
ATTENTION!
Distilled water in the cooking compartment leads to
corrosion.
▶ Do not use distilled water.
Mix 0.4litres water with a drop of washing-up liquid
and pour into the centre of the cooking compart-
ment floor.
3.
Press ⁠ to switch the appliance on.
4.
Press ⁠.
5.
Use the ⁠ or ⁠button to select "EasyClean" ⁠.
6.
Press the bottom row.
7.
Press ⁠ to start the cleaning aid.
a The cleaning aid will start. The duration will count
down on the display.
a Once the cleaning aid has run through to the end,
an audible signal will sound.
8.
Press any button to end the audible signal.