User's Manual
Table Of Contents
- Oven
- en
- Table of contents
- 1 Safety
- 2 Preventing material damage
- 3 Environmental protection and saving energy
- 4 Familiarising yourself with your appliance
- 5 Accessories
- 6 Before using for the first time
- 7 Basic operation
- 7.1 Switching on the appliance
- 7.2 Switching off the appliance
- 7.3 Residual heat indicator
- 7.4 Setting the type of heating and temperature
- 7.5 Changing the temperature
- 7.6 Changing the type of heating
- 7.7 Pausing operation
- 7.8 Cancelling operation
- 7.9 Viewing the current temperature
- 7.10 Displaying information
- 8 Time-setting options
- 9 Meat probe
- 10 Baking and roasting assistant
- 11 Childproof lock
- 12 Rapid heat-up
- 13 Sabbath mode
- 14 Basic settings
- 15 Home Connect
- 16 Cleaning and servicing
- 17 Cleaning functions
- 18 Rails
- 19 Appliance door
- 20 Troubleshooting
- 21 Disposal
- 22 Customer Service
- 23 How it works
- 24 Installation instructions
en Troubleshooting
30
20.1 Malfunctions
Fault Cause and troubleshooting
The appliance is not working. The circuit breaker is faulty.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other appliances are working.
"Language English" appears on
the display.
There has been a power cut.
▶
Configure the initial configuration settings.
→"Initial use", Page10
The appliance cannot be
switched on; appears on the
display.
Automatic childproof lock or childproof lock is activated
▶
Press and hold the button until "Childproof lock deactivated" appears on
the display.
Appliance will not start or cuts
out during operation.
Different causes are possible.
▶
Check any notifications that appear on the display.
→"Displaying information", Page12
Malfunction
▶
Call the after-sales service.
→"Customer Service", Page31
The appliance is not heating;
appears on the display.
Demo mode is activated in the basic settings.
1.
Briefly disconnect the appliance from the power supply by switching the cir-
cuit breaker in the fuse box off and then on again.
2.
Deactivate Demo mode within the next 3 minutes in the
→"Basic settings", Page17.
There has been a power cut.
▶
Open and close the appliance door once after a power failure.
a The appliance will perform a self-test, after which it will be ready to use.
Time not displayed when appli-
ance switched off.
Basic setting has been changed.
▶
Change the basic setting for the clock display.
→"Basic settings", Page17
Appliance door cannot be
opened.
The cleaning function locks the appliance door; is lit on the display.
▶
Allow the appliance to cool down until goes out on the display.
→"Self-cleaning function", Page21
The childproof lock locks the appliance door.
▶
Use the button to deactivate the childproof lock.
→"Childproof lock", Page15
You can switch off the lock in the basic settings.
→"Basic settings", Page17
HomeConnect is not working cor-
rectly.
Different causes are possible.
▶
Go to www.home-connect.com.
The interior lighting does not
work.
The LED light is defective.
Note:Do not remove the glass cover.
▶
Call the after-sales service.
→"Customer Service", Page31
Maximum operating time
reached.
To prevent the appliance from continuing to run when it is no longer needed, it
automatically stops heating after a few hours if the settings are not changed dur-
ing this time. A notification appears on the display.
The point at which the maximum operating time is reached is determined by the
corresponding settings for an operating mode.
1.
Press any button to continue operation.
2.
If you do not need to use the appliance, press to switch it off.
Tip:To prevent the appliance from switching off when you do not want it to, set
a cooking time.
→"Setting the cooking time", Page12