User's Manual
Table Of Contents
- Oven
- en
- Table of contents
- 1 Safety
- 2 Preventing material damage
- 3 Environmental protection and saving energy
- 4 Familiarising yourself with your appliance
- 5 Accessories
- 6 Before using for the first time
- 7 Basic operation
- 7.1 Switching on the appliance
- 7.2 Switching off the appliance
- 7.3 Residual heat indicator
- 7.4 Setting the type of heating and temperature
- 7.5 Changing the temperature
- 7.6 Changing the type of heating
- 7.7 Pausing operation
- 7.8 Cancelling operation
- 7.9 Viewing the current temperature
- 7.10 Displaying information
- 8 Time-setting options
- 9 Meat probe
- 10 Baking and roasting assistant
- 11 Childproof lock
- 12 Rapid heat-up
- 13 Sabbath mode
- 14 Basic settings
- 15 Home Connect
- 16 Cleaning and servicing
- 17 Cleaning functions
- 18 Rails
- 19 Appliance door
- 20 Troubleshooting
- 21 Disposal
- 22 Customer Service
- 23 How it works
- 24 Installation instructions
Appliance door en
27
5.
WARNING‒Risk of injury!
If the door locks are unsecured, the appliance door
may become detached.
▶
After attaching the appliance door, close the left-
and right-hand door locks.
Hold the screwdriver horizontally and use it to
push the door lock (black component) on each side
of the door downwards as far as it will go .
a The door lock is closed.
19.3 Removing the door panes
To facilitate cleaning, you can remove the door pane.
WARNING‒Risk of injury!
Components inside the appliance door may have sharp
edges.
▶
Wear protective gloves.
Requirement:The appliance door is detached.
1.
Lay the appliance door with the front side facing
down on a flat surface that is soft and clean.
2.
Push on the left- and right-hand side of the appli-
ance door from the outside until the inner pane is
released on both sides.
3.
Carefully lift the inner pane and remove it in the dir-
ection of the arrow .
4.
Slide the screwdriver in between the metal tab
and the plastic.
5.
Use the screwdriver to lift the reflector until it
disengages, then lift it up and pull it out.
6.
Remove the second reflector in the same way as
the first.
7.
Push down on the intermediate pane lightly in the
area of , and carefully lift the retainer until you
are able to pull it out.
8.
Lift the first and second intermediate panes from be-
low and remove them in the direction of the arrow
.