Assembly & Installation Instructions
Table Of Contents
- Oven
- en
- Table of contents
- 1 Safety
- 2 Preventing material damage
- 3 Environmental protection and saving energy
- 4 Familiarising yourself with your appliance
- 5 Accessories
- 6 Before using for the first time
- 7 Basic operation
- 7.1 Switching on the appliance
- 7.2 Switching off the appliance
- 7.3 Residual heat indicator
- 7.4 Setting the type of heating and temperature
- 7.5 Changing the temperature
- 7.6 Changing the type of heating
- 7.7 Pausing operation
- 7.8 Cancelling operation
- 7.9 Viewing the current temperature
- 7.10 Displaying information
- 8 Time-setting options
- 9 Meat probe
- 10 Baking and roasting assistant
- 11 Childproof lock
- 12 Rapid heat-up
- 13 Sabbath mode
- 14 Basic settings
- 15 Home Connect
- 16 Cleaning and servicing
- 17 Cleaning functions
- 18 Rails
- 19 Appliance door
- 20 Troubleshooting
- 21 Disposal
- 22 Customer Service
- 23 Declaration of Conformity
- 24 How it works
- 25 Installation instructions
- 25.1 General installation instructions
- 25.2 Appliance dimensions
- 25.3 Installation below a worktop
- 25.4 Installation underneath a hob
- 25.5 Installation in a tall unit
- 25.6 Installing two appliances on top of each other
- 25.7 Corner installation
- 25.8 Electrical connection
- 25.9 Installing the appliance
- 25.10 Removing the appliance
en Appliance door
28
9.
Lift the first and second intermediate panes from be-
low and remove them in the direction of the arrow
.
10.
Remove the spacers and seals for cleaning, if
required.
11.
WARNING‒Risk of injury!
Scratched glass in the appliance door may develop
into a crack.
▶ Do not use any harsh or abrasive cleaners or
sharp metal scrapers to clean the glass on the
oven door, as they may scratch the surface.
ATTENTION!
Damage to the lighting.
▶ Do not clean or touch the LEDs . The LEDs
are located on the right- and left-hand side in the
appliance door.
Clean the door panes and reflectors on both sides
with glass cleaner and a soft cloth.
12.
Dry the door panes and refit them.
19.4 Fitting the door panes
WARNING‒Risk of injury!
If a door pane or appliance door has not been installed
correctly, this is dangerous.
▶ Make sure that all of the door panes and the appli-
ance door have been correctly fitted before you
switch the appliance back on again.
1.
Tip:When fitting the door panes, make sure that
they are in the original order.
Insert the intermediate pane so that the arrow on
the right-hand side is pointing upwards.
2.
Check the fit of the four spacers and two seals.
‒ Place the spacers on the centre of the lines .
‒ Secure the seals at the corners .
3.
Insert the intermediate pane with spacers and seals
in the direction of the arrow .
The arrow on the intermediate pane must line up
with the arrow on the frame .
4.
Insert the second intermediate pane without the
spacers and seals, and slide it in the direction of the
arrow until it is inserted in the sheet metal frame .
The arrow on the intermediate pane must line up
with the arrow on the frame .