Assembly & Installation Instructions

en Appliance door
30
20.2 Attaching the appliance door
1.
Tip:Ensure that the appliance door is not wedged
at an angle and that it is properly fitted in place.
Attach the appliance door via the left- and right-hand
guide rollers simultaneously ⁠.
2.
Rotate the door handle upwards slightly ⁠.
a The appliance door slides the short distance re-
maining to the bottom ⁠.
3.
Use a coin to release both locks on the appliance
door. Insert the coin in the gap in the lock ⁠ and ro-
tate as far as it will go ⁠.
‒ Turn the lock on the left-hand side in an anti-
clockwise direction.
‒ Turn the lock on the right-hand side in a clock-
wise direction.
4.
Open the appliance door slightly until you hear a
quiet click, and then close the appliance door.
5.
WARNING‒Risk of injury!
If the door locks are unsecured, the appliance door
may become detached.
▶ After attaching the appliance door, close the left-
and right-hand door locks.
Hold the screwdriver horizontally ⁠ and use it to
push the door lock (black component) on each side
of the door downwards as far as it will go ⁠.
a The door lock is closed.
20.3 Removing the door panes
To facilitate cleaning, you can remove the door pane.
WARNING‒Risk of injury!
Components inside the appliance door may have sharp
edges.
▶ Wear protective gloves.
Requirement:The appliance door is detached.
1.
Lay the appliance door with the front side facing
down on a flat surface that is soft and clean.
2.
Undo and remove the left- and right-hand screws on
the appliance door.
3.
Carefully lift the inner pane upwards at an angle ⁠
and remove the holder ⁠ ⁠.