User Manual

Appliance door en

Caution!

Make sure you do not damage the lighting. Do not

clean or touch the LED ‚ in the appliance door.

12. Dry the door panels and refit them.

Fitting

Note: When fitting the glass door panels, ensure that

they are in the original order.

1. Insert the intermediate glass panel and push it in the

direction of the arrow until it is fitted in the frame. The

arrow on the intermediate glass panel must line up

with the arrow on the frame (Fig. !).

2. Push the intermediate glass panel downwards in

area ‚, insert holder ƒ at an angle and push down

until it locks into place (Fig. ").

The holder is inserted (Fig. #).

Caution!

Do not touch the glass rod with bare fingers. Fatty

deposits decrease the effect of light transfer. Clean

the glass rod with glass cleaner once it has been

inserted.

3. Select the left-hand reflector (Fig. $).

4. Insert the left-hand reflector „ at the top (Fig. %).

5. Insert reflector „ (Fig. &).

6. Fit reflector „ into slot … (Fig. ').

7. Insert the second

reflector on the right-hand side in the same way as

the left-hand reflector.

8. If necessary, use glass cleaner to remove any finger

marks from the reflectors.

9. Insert the inner glass panel into holder † on the left-

and right-hand side (Fig. ().

10. Push down on the inner glass panel until it locks into

place (Fig. )).













