Assembly & Installation Instructions

Table Of Contents
Rails en
21
9.
After using the cleaning aid, finish cleaning the
cooking compartment.
→"Wiping down the cooking compartment",
Page21
Wiping down the cooking compartment
ATTENTION!
The prolonged presence of moisture in the cooking
compartment leads to corrosion.
After using the cleaning aid, wipe the cooking com-
partment clean and allow it to dry fully.
Requirement:The cooking compartment must have
cooled down.
1.
Open the appliance door and remove the remaining
water with an absorbent sponge cloth.
2.
Clean the smooth surfaces in the cooking compart-
ment with a dish cloth or a soft brush. Remove stub-
born food remnants using a stainless steel scouring
pad.
3.
Remove limescale with a cloth soaked in vinegar.
Then wipe with clean water and rub dry with a soft
cloth (including under the door seal).
4.
If there is any stubborn dirt that you are unable to
remove, run the cleaning aid again once the cook-
ing compartment has cooled down.
5.
In order to dry the cooking compartment, leave the
appliance door open in the detent position (approx.
30°) for approx.one hour.
17  Rails
To thoroughly clean the rails and the cooking compart-
ment, or to replace the rails, you can remove the rails.
17.1 Changing the shelf position for the
telescopic shelf
The bars and telescopic shelves can be positioned in
any order.
For example, you can fit the telescopic shelf to the
shelf position which you use the most frequently.
Removing the bar
Note:Telescopic shelves are removed and fitted like
bars.
1.
Push the bar towards the rear until it can be
pulled out upwards ⁠.
2.
Unhook the bar at the rear and remove it.
Fitting the bar
1.
Fit the bar at the back ⁠.
2.
Slide the bar towards the back and hook it down-
wards onto the pin ⁠.
3.
Ensure that the hook is hooked onto the pin ⁠.
Detaching the rails
WARNING‒Risk of burns!
The shelf supports get very hot
Never touch the shelf supports when hot.
Always allow the appliance to cool down.
Keep children at a safe distance.
1.
Lift the rail forwards slightly and detach it ⁠.