User's Manual

Use of guidelines
●After the power is turned on, press "RUN" to turn
the light on or off.
4.Channel / Group
●Connect AC power supply
●Press the ON / OFF button to turn on the power,
and the digital display panel in on.
1. Start Using led Lights
2.LED light switch
●After the power is turned on, the adjusting knob
to adjust the power.
●Adjustable power range: 10 % -100 %
3.Brightness
●Press”GR/CH” knob until “ ”flicker in the
display.then select the dial setting(1-16) channel,
and then press the dial key to confirm;
Press”GR/CH” knob until “ ”flicker
in the display, then select the dial setting(0-9,
A-F) group, and then press the dial key to confirm.
Remote control
Wireless icon
Brightness
Light icon
Color temperature
Channel
Group
+ key - key
Color temperature
button
Channel button
Remote control
power switch
LED light switch
Group key
SET key
Press the < > button to control the LED light on or off
Press<+>, <->to adjust the brightness of the light
Press the "CH" key, flicker < >on the screen, and press the <+>
<-> key to set the channel.
Press the "GR" key, flicker < > on the screen, and then press the
"+" "-''-'' key to set the group.
Note:*Please keep the same channel and same group for light and remote .
*If the light without color temperature adjustment function, the “COLOR”( color
temperature )key is not supported.
*It will take 8 seconds for the remote control parameter setting to be
memorized and saved
(Remote control purchased by separately)
This light always detects the temperature of LED light .When the temperature
too high,the light will be turn off .
Temperature detection
Note: the flash parameters will not be stored until 8 seconds after setting.