Safety Instructions
Table Of Contents
- Regulatory Compliance & Safety Information for Control4 Model NE-RMT
- Regulatory Compliance & Safety Information for Control4 Model NE-RMT
- Electrical Safety Advisory
- Electrical Safety Advisory
- FCC Part 15, Subpart B Unintentional Emissions Interference Statement
- FCC Part 15, Subpart B Unintentional Emissions Interference Statement
- This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is opera...
- This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is opera...
- This device complies with part 15 of the FCC rules and Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference re...
- This device complies with part 15 of the FCC rules and Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference re...
- FCC Part 15, Subpart C / RSS-247 Intentional Emissions Interference Statement
- FCC Part 15, Subpart C / RSS-247 Intentional Emissions Interference Statement
- Déclaration d'exposition aux radiations RF Cet équipement est conforme aux limites FCC / IC d'exposition aux rayonnements définies quatrième opération appareils portables transmettre dans un environnement non contrôlé. Les utilisateurs finaux doivent ...
- Déclaration d'exposition aux radiations RF Cet équipement est conforme aux limites FCC / IC d'exposition aux rayonnements définies quatrième opération appareils portables transmettre dans un environnement non contrôlé. Les utilisateurs finaux doivent ...
- Europe Compliance
- Europe Compliance
- Recycling
- Recycling
- European Compliance
- European Compliance
This radio transmitter has been approved by Industry Canada to operate with the antenna type
listed below with the maximum permissible gain indicated. Antenna types not included in this list,
having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use
with this device.
Manufacturer: Optiprint AG
Model: NPNM00088
Maximum Gain: 2.4 GHz (-8.0 dBi)
Cet émetteur radio a été approuvé par Industrie Canada pour fonctionner avec le type d'antenne
indiqué ci-dessous avec le gain maximal admissible indiqué. Les types d'antennes non inclus
dans cette liste, ayant un gain supérieur au gain maximal indiqué pour ce type, sont strictement
interdits pour une utilisation avec cet appareil.
Manufacturer: Optiprint AG
Model: NPNM00088
Maximum Gain: 2.4 GHz (-8.0 dBi)
RF Radiation Exposure Statement
This equipment complies with the FCC/IC radiation exposure limits set fourth for portable
transmitting devices operation in an uncontrolled environment. End users must follow the specific
operating instructions to satisfy RF exposure compliance.
• The equipment should only be used or installed at locations where there is normally
greater than a 20cm separation between the antenna and all persons.
• This transmitter must not be co-located or operation in conjunction with any other
antenna or transmitter.
• Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
Déclaration d'exposition aux radiations RF
Cet équipement est conforme aux limites FCC / IC d'exposition aux rayonnements définies
quatrième opération appareils portables transmettre dans un environnement non contrôlé. Les
utilisateurs finaux doivent suivre les instructions de fonctionnement spécifiques pour satisfaire la
conformité aux expositions RF.
• L'équipement ne doit être utilisé ou installé à des endroits où il est normalement
supérieure à une séparation de 20 cm entre l'antenne et toute personne.
• Cet émetteur ne doit pas être co-localisés ou fonctionnement en conjonction avec une
autre antenne ou un autre émetteur.
• Tout changement ou modification non expressément approuvé par la partie responsable
de la conformité pourraient annuler l'autorité de l'utilisateur à utiliser cet équipement.
Europe Compliance
Compliance of this equipment is confirmed by the following logo that is placed on the product ID
label that is placed on the bottom of the equipment. The full text of the EU Declaration of
Conformity (DoC) is available on the following pages: