User's Manual
Table Of Contents
Smartcard-Booster LEGIC
© Nedap AVI, P.O. Box 103, NL-7140 AC GROENLO Page 8 of 16
3.3.1 CREATE A CONFIGURATION CARD
The configuration card contains the information which user cards are supported and which data on these cards
must be read. Follow the procedure below to create a configuration card.
1. Specify the OPTIONS (see chapter 3.3.1.1)
2. Specify the SEARCH DEFINITIONS (see chapter 3.3.1.3)
3. Specify the DATA DEFINITIONS (see chapter 3.3.1.4)
4. Load the Master Token IAM.
Place the master token card on the programmer and click 'Authorization', 'Add'.
The message 'Authorization accepted' should appear.
5. `Write the configuration into a transponder.
Place the booster configuration card on the programmer and click 'Configuration', 'Write TXP'.
The message 'Configuration data written' should appear.
The configuration can be saved in a bcf-file.
3.3.1.1 OPERATING MODE
Operating modes:
Dual-ID (Vehicle-ID + Driver-ID)
Driver-ID max. 40 bits (=5 bytes) from LEGIC smart card.
Single-ID (only Driver-ID)
Driver-ID max. 80 (=10 bytes) bits from LEGIC smart card.
Extended Driver-ID operating modes:
Dual-ID (Vehicle-ID + Driver-ID)
Driver-ID max. 88 bits (=11 bytes) from LEGIC smart card.
Single-ID (only Driver-ID)
Driver-ID max. 128 bits (=16 bytes) from LEGIC smart card.