User's Manual

Smartcard-Booster LEGIC

3 CONFIGURATION

The Smartcard-Booster LEGIC is configured by means of configuration cards. This configuration card is a LEGIC

Advant transponder that contains all the information that is required to find the user's segment and read the

data. The Smartcard-Booster LEGIC only accepts a configuration card after configuration is enabled with a master

token card.

A newly purchased booster will accept any master token card. Once a master token has been inserted, the

booster will only accept that specific master token and cannot be reconfigured with other master tokens.

3.1 CONFIGURATION CARD SET

The configuration card set contains 3 cards that have the exact same stamp.

• The master token IAM n/31 enables the programmer to write the configuration card.

• The master token SAM n/31 enables the booster to accept the configuration card.

• The configuration card.

Note: Previously the set contained only 2 cards. The IAM n/31 card was accepted on the Booster aswell as on

the programmer.

A special master token SAM n/32 or IAM n/32 can be purchased to perform a 'master token withdraw'. This w ill

reset the booster so that it accepts any master token (just like a maiden booster). The 'withdraw' master token

should have the exact same stamp as the original master token.

3.2 CONFIGURATION PROCEDURE

Follow the procedure below to configure the Smartcard-Booster LEGIC for your application.

1. Insert the master token card in the Booster and push the button.

The Booster sounds the buzzer with an increasing frequency (

♪

). The Booster will now accept your

configuration data card.

2. Insert the configuration data card in the Booster and push the button.

The Booster sounds the buzzer with a decreasing frequency (

♪

)

to indicate that the configuration is

accepted. Now your booster will read the LEGIC smart cards that meet the conditions defined in your

configuration.