User's Manual
Table Of Contents
Smartcard-Booster LEGIC
© Nedap AVI, P.O. Box 103, NL-7140 AC GROENLO Page 12 of 16
3.4 TESTING THE CONFIGURATION
The configuration can be tested on your read/write unit with the LEGIC cards that should be supported. This test
can be performed before the configuration cards are created and without any Boosters.
3.4.1 SETUP TEST ENVIRONMENT
First the configuration must be transmitted to the programmer.
This is done by clicking 'Configuration', 'Test' and 'Setup configuration in read/write unit'. The message 'Setup
Test Configuration completed successfully' should appear.
The test configuration is w ritten into the programmer's RAM IDB settings.
3.4.2 START TESTING
Start reading by clicking 'Configuration', 'Test' and 'Start Reading' (or press F9).
When a transponder is found that meets the configured search definitions a message appears with the data that
was read.
Read data information message
The reading can be aborted by clicking 'Configuration', 'Test' and 'Stop Reading' (or press Shift + F9).