User's Manual
Table Of Contents
Smartcard-Booster LEGIC
© Nedap AVI, P.O. Box 103, NL-7140 AC GROENLO Page 11 of 16
3.3.2 EXAMPLE CONFIGURATION
In this chapter will be explained how to setup the configuration to accept LEGIC transponders with a Kaba Group
Header segment.
3.3.2.1 OPERATING MODE
Operating mode
Dual-ID Vehicle-ID and driver-ID.
Extended Driver-ID length
no not used
3.3.2.2 RFID OPTIONS
Enable ISO15693
yes LEGIC Advant enabled
Enable ISO14443A
no not used
Enable LEGIC prime
yes LEGIC prime enabled
Enable Inside Contactless
no not used
Enable FeliCa
no
not used
Enable ISO14443B
no not used
3.3.2.3 SEARCH DEFINITION
Search enable
With segment search Search for a segment.
Segment number
1 Start searching at segm ent 1.
Segment type
Data segment Segment must be a data segment.
Segment stamp search
02 Segment stamp should start with 02.
Stamp length
4 KGH defines a stamp length of 4 bytes.
3.3.2.4 DATA DEFINITION
Allocation of data to search
definition
1 Allocate data to search definition 1.
Data type
Segment data Read data from the searched segment.
Data address
0 Start reading at first byte after the stamp.
Data length
3 Read 3 bytes.
3.3.3 BOOSTER CONFIG FILES
Your configuration can be saved into a Booster Config File (*.bcf). These files contain all the configuration
settings as you have defined them. Saved Booster Config Files can be easily opened from within the File menu.