User Manual

BOOSTER 2G | USER GUIDE
Smartcard Configuration
9/27
4 SMARTCARD CONFIGURATION
The Smartcard-Booster can be configured by means of a configuration card. This
configuration card is a Mifare Classic 1K or 4K card that is programmed with the
configuration settings.
Configuration is only required if the factory default settings are not sufficient. The
default settings are described in chapter 4.2.3.
4.1 CONFIGURATION PROCEDURE
Every Booster used in the application should be configured with the configuration
card. The simple configuration procedure is described below.
Insert the configuration card in the Booster and push the button. The Booster sounds
the buzzer with an increasing frequency (
♪
♪
♪
) to indicate that the configuration
card is accepted.
4.2 HOW TO CREATE A CONFIGURATION CARD
NEDAP has developed a software application that allows system integrators to
create configuration cards. This software can be downloaded from our website
1TUwww.Nedapidentification.comU1T
Smartcard-Booster Config software