User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 INSTALLATION
- 3 SMARTCARD CONFIGURATION
- 4 MTR CONFIGURATION
- 5 IDENTIFYING THE BOOSTER WITH A TRANSIT
- 6 BUZZER INDICATIONS
- 7 BATTERY REPLACEMENT
- A TECHNICAL SPECIFICATIONS
- B PART NUMBERS
BOOSTERS
© Nedap IDEAS, P.O. Box 103, NL-7140 AC GROENLO Page 9 of 16
3.2.3 DEFAULT CONFIGURATION
In the table below the factory default configuration is shown.
Configuration settings Default value
Operating mode Combi-Booster (Vehicle-ID + Driver-ID)
Frame length Extended-length (longer Driver-ID)
Enable HID iCLASS CSN Yes
Enable ISO14443-A / MIFARE Yes, ISO14443-A card serial number
Enable ISO15693 / LEGIC Advant CSN Yes
Enable NEDAP PM Yes
Enable EM4102 or compatible Yes
Enable HID PROX Yes
Please use the table below to fill-in your application specific settings.
Configuration settings Value
Operating mode
Frame length
Enable HID iCLASS CSN
Enable ISO14443-A / MIFARE
Data to read
Sector number
Block number
Data length
Data offset
Read key A or B
Enable ISO15693 / LEGIC Advant CSN
Enable NEDAP PM
Enable EM4102 or compatible
Enable HID PROX