User's Manual
Table Of Contents
- 1 INTRODUCTION
- 2 INSTALLATION
- 3 SMARTCARD CONFIGURATION
- 4 MTR CONFIGURATION
- 5 IDENTIFYING THE BOOSTER WITH A TRANSIT
- 6 BUZZER INDICATIONS
- 7 BATTERY REPLACEMENT
- A TECHNICAL SPECIFICATIONS
- B PART NUMBERS
BOOSTERS
© Nedap IDEAS, P.O. Box 103, NL-7140 AC GROENLO Page 5 of 16
3 SMARTCARD CONFIGURATION
The Smartcard-Booster and the Transition-Booster can be configured by means of a configuration card.
This configuration card is a Mifare Classic 1K or 4K card that is programmed with the configuration
settings.
Configuration is only required if the factory default settings are not sufficient. The default settings are
described in chapter
3.2.3.
3.1 CONFIGURATION PROCEDURE
Every Booster used in the application should be configured with the configuration card. The simple
configuration procedure is described below.
Insert the configuration card in the Booster and push the button. The Booster sounds the buzzer with an
increasing frequency (
♪
♪
♪
) to indicate that the configuration settings have been accepted.
n
3.2 HOW TO CREATE A CONFIGURATION CARD
NEDAP has developed a software application that allows system integrators to create configuration
cards. This software can be downloaded from our website
www.nedapavi.com.
Smartcard-Booster Config software
n
See chapter 6 for details about the buzzer indications.