User's Manual

Table Of Contents

BOOSTERS

6 BUZZER INDICATIONS

The Booster's built-in buzzer gives audible feedback upon various conditions. The table below describes

the buzzer indications.

Buzzer Description

1 beep Transponder read

1 short low beep Transponder not read (not in configuration)

3 beeps increasing frequency

♪

Configuration card accepted

6 beeps increasing frequency Power on (Smartcard-Booster / Transition-Booster / MTR)

3 beeps Power on (Prox-Booster)

7 BATTERY REPLACEMENT

The Smartcard-Booster and Transition-Booster contain two replaceable non-rechargeable lithium AAA

batteries. The average lifetime of these batteries is approximately 5 years. When replacement becomes

necessary follow the procedure below.

1. Unscrew the four screws on the bottom of the Booster and carefully open the housing.

2. Remove both batteries. Follow local environment protection laws / regulations for disposal of used

batteries.

3. Replace with two new batteries of same type. Make sure that the polarity matches the indicated

polarity.

4. Before closing the housing make sure that the coil (displayed in red in the picture below) is positioned

correctly on the three stand-offs.

5. Place the cover on the housing and tighten the four screws back in place.

The Prox-Booster contains a non-rechargeable lithium battery which is soldered in place. The average

lifetime of this type of battery is approximately 5 years. When replacement becomes necessary, contact

Nedap about the battery replacement program.