User Manual
Table Of Contents
- Introduction
- Product overview
- Preparing the installation
- Executing the installation
- Configuring the installation
- Integrating the installation with other systems
- System behavior
- Servicing the installation
- Troubleshooting
- Regulatory information
- About Nedap
Page of 41 59 Manual iSense Lumen series
Status of LEDs before configuration
When the system is not configured yet, the RFID reader will not be active. This means that only the
'firmware running' orange LED is blinking.
AVCC unit
Color Status Explanation
Blue
on Renos is running
blinking Renos is starting up
off The gate is powerednot
Green
on The system is connected to Nedap Device Management & Analytics
off There is connection to Nedap Device Management & Analyticsno