User Manual
Table Of Contents
- Introduction
- Product overview
- Preparing the installation
- Executing the installation
- Configuring the installation
- Integrating the installation with other systems
- System behavior
- Servicing the installation
- Troubleshooting
- Regulatory information
- About Nedap
Page of 10 59 Manual iSense Lumen series
Connections
Here a Renos unit is displayed, with a description of all its connectors and what they are used for.
Number Connector Usage
1 50 ohm
Connect the Renos unit to the 50 ohm PCB. The 50 ohm PCB connects both the light and the
RF antenna.
2 Lights/IR Connects to the audiovisual signalling and the customer counter.
3 Add-on Provide power and synchronization to add-ons, like the RFID reader.
4 Network IN Connected to the Network OUT of a previous Renos unit or a Power Inserter.
5 USB Connect accessories to Renos, like the RFID Reader.
6 Network OUT
Connected to the Network IN of a next unit or a Power Inserter. Can also be left unconnected
or connected to the customer network.
7
Mini USB
service port
Connect your laptop to configure the Renos system.
8
RS485
connector
Connect to the optional Nedap RF Smart Deactivator.
9
Buzzer
connector
Connection to buzzer is not possible for products in the iSense Lumen series. Alarm
signalling is created in