User Guide

OEM Design-in Guide
Luxon IoT Node Outdoor
8
Device ID
Below we explain the functionality of the green led before and after commissioning when the Luxon IoT Node Outdoor in
powered up. The Luxon IoT node is factory default not commissioned.
With the Luxon floorplanner the Luxon IoT Node Outdoor need to be commissioned to assign the node to the Luxon Light
Controller (LLC).
Green LED functionality before commissioning
1: Green led quick flashing (10Hz) : Self-test of 1 second
2: Green led slow flashing (0.5Hz): Addressing DALI Drivers; In case of 1-10V drivers, this phase is skipped.
3: Green led on: Driver initialization ready and no failures
Green LED functionality after commissioning
1: Green led quick flashing (10Hz) : Self-test of 1 second
2: Green led on for 1 second and then turns off.
The red LED starts flashing red to indicate a failure. This failure could be:
A: No control mode (Active DALI, DALI or 1-10V dim-to-off) is detected due to incorrect wiring or a defective driver.
B: A driver status error occurred due to defect in driver, driver load or wiring.
C: An overcurrent on the D+/1-10V control line occurred, due to connecting a power supply to the control line.
The Luxon IoT Node Outdoor has a built-in temperature sensor which can be requested the Luxon light management
system. The range of the temperature sensor is -40°C/-40°F to +100°C/+212°F, however in normal operation the maximum
internal temperature is 80°C/176°F.
The Luxon IoT node outdoor has an integrated light sensor to measure lux values from 0 to 1000 lux. The lux sensor will be
used in the future to support twilight switch functionality.
The Luxon IoT Node Outdoor supports motion sensors with a 0-10V, OC (open collector) or potential free contact interface,
see chapter 5.4 for more information and supported sensors.
To communicate to every single device in the mesh network, every Luxon IoT Node Outdoor has an unique device ID.
See the image below where you can find the device ID on the Luxon IoT Node Outdoor.
3.4 LED indicator
3.5 Temperature sensor
3.6 Lux sensor
3.7 Motion sensor input
3.8 Device ID