User Guide

OEM Design-in Guide
Luxon IoT Node Outdoor
16
To power the Luxon IoT Node Outdoor and / or third party sensors, an auxiliary power supply can be used in cases that the
LED driver has no auxiliary power supply available or has no active DALI port like Philips SR or Osram Dexal.
In this chapter , the Luxon IoT Node Outdoor power supply requirements are shown followed by additional requirements for
auxiliary power supplies and location of compatible 24V power supplies.
Requirements Power Supply
In the table below the power supply requirements for the Luxon IoT node Outdoor are specified.
Control
Interface
Voltage (V)
Min. operating
Current (mA)
Max. operating
Current (mA)
Inrush
Current (mA)
1-10V
12 or 24V ± 10%
6
20
50
DALI
24V ± 10%
6
20
50
Additional Requirements Auxiliary Power Supply
In case the IoT node is used without sensor, the table above shall be used to find the power supply output specification. In
case an additional sensor is used:
- its operating voltage range shall correspond with the chosen value for the Luxon IoT Node Outdoor (12 or 24V)
- its current shall be added to the current for the IoT node to obtain the total operating supply current
Other supply requirements to be considered:
-minimum load specification of 6mA or less
-the maximum Ta or Tc shall not be exceeded
-evaluate if output derating is required in case of high operating temperature
-the supply lifetime shall match the luminaire lifetime
-the mains surge protection level shall match the luminaire protection level
-some power supplies require a mains fuse
-the input mains voltage range shall match
Compatible 24V Auxiliary Power Supplies
For an overview of electrical compatible auxiliary power supplies, please refer to portal.nedap-luxon.com.
The Luxon IoT Node Outdoor is designed for Luminaires with a NEMA ANSI C136.41-2013 receptacle. Safe and reliable
operation requires that the end-product complies with the relevant standards and regulations. The manufacturer of the end-
product remains responsible for the quality and performance of the luminaire with the Luxon IoT Node Outdoor in
compliance with the contents of this OEM Design Guide as well as for the total system in the market. The ratings in the
specifications of the Luxon IoT Node Outdoor shall not be exceeded when it is used in the actual operating conditions.
5.4 Auxiliary Power Supply
5.5 Product responsibility