User Guide

OEM Design-in Guide
Luxon IoT Node Outdoor
14
Luxon Motion sensor color coding:
0V wire = brown
Signal wire S = white
Diagram A: Connecting a Luxon motion sensor
The white wire of the Luxon Motion Sensor is connected to the sensor input “Sens” of the Luxon IoT Node Outdoor.
And the brown wire to the “Dim-“ wire of the Luxon IoT Node Outdoor.
5.3.2 Third party motion sensors
Third party motion sensors shall be connected as shown in diagram B. Note that third party sensor requires a 12V or 24V
external supply voltage, either from the LED driver or from an auxiliary power supply, see chapter 5.5. In case of a sensor
with programmable time delay settings make sure they are set to the lowest value, either by factory default (preferred) or
by hand or using a programming device. Also disable the sensor light dependent switch if applicable.
Diagram B: Connecting a third party motion sensor