User Guide

OEM Design-in Guide
Luxon IoT Node Outdoor
13
The RF radiation pattern of the Luxon IoT Node Outdoor is directed mainly in one direction as showed is the picture below.
Requirements to give the antenna the best possible free 360° RF communication performance:
- Avoid metal parts close to the antenna.
- Avoid large horizontal oriented metal parts within 75mm or 3” measured from the center of the antenna.
The Luxon IoT Node Outdoor sensor input is a universal sensor input for the Nedap motion sensor and several third party
motion sensors.
The sensor input is compatible with sensors which have an analog 1-10V interface, an open collector output or potential
free low current relay contacts. The sensor input has an ON/OFF programmable current source of 2mA maximum.
5.3.1 Luxon motion sensor
The Luxon motion sensor is an PIR high bay 12m / 39ft motion sensor which can be easily connected to the Luxon IoT Node
Outdoor without an auxiliary supply. This sensor is IP65 and can be universally used indoor and outdoor.
A masking set can be ordered separately.
Description Part number
Luxon Motion Sensor 12m/39ft universal mount 9984526
Lens Mask Set 4605675
The Luxon Motion Sensor shall be connected as shown in diagram A by using appropriate wire connectors.
The Luxon Motion Sensor cable shall not be lengthened.
5.2 Position and RF performance
5.3 Supported motion sensors