User manual

5．Operation of electric ironing machine
HOW TO EMPTY THE WATER TANK WHEN NOT IN USE
IF THERE IS ONLY A SMALL AMOUNT OF WATER LEFT
IN THE TANK THEN A MOCK STEAM IS BEST. YOU DO
THIS BY CONTINUING TO STEAM ON AN OLD TOWEL OR
PIECE OF FABRIC UNTIL ALL THE WATER IS GONE
IF THERE IS A LOT OF WATER LEFT IN THE TANK THEN
R E M O V E T H E L I D F R O M T H E S P R AY B O T T L E
GENTLY PULL OUT THE WATER CONTAINER HALF WAY
AND INSERT THE TUBE INTO THE TANK AND THEN
SYPHON OFF THE WATER INTO A SUITABLE CONTAINER.
1. Before inserting power cord
A. It is required to check if the voltage indicated for the base of the machine shall be identical to the voltage of
power supply you are using.
B. Place the steam press on a stable surface it is recommended to place a protective cover on the surface under
the press.
2. Water filling
During water filling, it is required to switch off power supply, pull out the water tank under the base half way, fill
water into the water jug and then fill the water into water tank.
Normally it is required to fill in 450ml water, and then push the water into the base (the water tank shall be pushed
into the base completely).
Note: There is filtration sponge on inlet of
water tank and water shall be filled
in slowly.
MAX:
M I N :
450ml
100ml
9
MAX
400 ml
200 ml
300 ml
MIN
M
AX
4
0
0m
l
200m
l
3
0
0
m
l
MI
N
UNLO
CK L
O
CK